Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Card Reader 3.5" with remote control
Item no. 87 15 45
1.
Intended use
The product is intended for installation in a 3.5" slot of a computer enclosure. On the front, there is a card reader for reading
out / recording cards of different types and a USB port. The remote control included is for controlling Windows Media Center
Edition (MCE).
Unauthorised conversion and/or modification of the device are inadmissible because of safety and approval reasons (CE). Any
usage other than described above is not permitted and can damage the product and lead to associated risks such as short-circuit,
fire, electric shock, etc. Please read the operating instructions thoroughly and keep them for further reference.
The product corresponds to the valid national and European regulations. All company names and product designations contained
herein are trademarks of the respective owners. All rights are reserved.
2.
Content of delivery
•
3.5" card reader
•
Remote control
•
4x screws
•
CD (infrared driver and Smart/SIM card editor)
•
Operating instructions
3.
Safety instructions
We do not assume liability for resulting damages to property or personal injury if the product has been
abused in any way or damaged by improper use or failure to observe these operating instructions. The
warranty/ guarantee will then expire!
The icon with exclamation mark indicates important information in the operating instructions. Carefully
read the whole operating instructions before operating the device, otherwise there is risk of danger.
Personal safety
•
The product is not a toy and should be kept out of reach of children!
Product safety
•
When used in conjunction with other devices, observe the operating instructions and safety notices of connected devices.
•
The product must not be subjected to heavy mechanical stress.
•
The product must not be exposed it to extreme temperatures, direct sunlight, intense vibration, or dampness.
Battery safety
•
Correct polarity must be observed while inserting the batteries.
•
Batteries should be removed from the device if it is not used for a long period of time to avoid damage through leaking.
Leaking or damaged batteries might cause acid burns when in contact with skin, therefore use suitable protective gloves
to handle corrupted batteries.
•
Batteries must be kept out of reach of children. Do not leave the battery lying around, as there is risk, that children or pets
swallow it.
•
All the batteries should be replaced at the same time. Mixing old and new batteries in the device can lead to battery leakage
and device damage.
•
Batteries must not be dismantled, short-circuited or thrown into fire. Never recharge non-rechargeable batteries. There is
a risk of explosion!
Miscellaneous
•
Servicing, adjustment or repair works must only be carried out by a specialist/ specialist workshop.
•
If any questions arise that are not answered in this operating instruction, contact our Technical Advisory Service or other
experts.
4.
Operating elements
1
2
3
11
1 Infrared LED
2 xD 1.21 slot
3 SmartCard slot
4 SD/mini SD/MMC/RS&4.2 slot
5 micro SD slot
6 SIM slot
5.
Driver installation
There is an infrared driver and an editor for SIM and smart cards on the CD. Insert the CD and follow the instructions. In case the
CD does not start by itself, manually open the file with the name "autorun" on the CD.
Version 02/09
4
5
6
7
8
10
9
7 M2 slot
8 Power/card reader LED
9 USB port
10 MS/MS PRO DUO slot
11 CFI/CFII slot
12 Windows MCE remote control
6.
Installation
When in doubt about how to install the device correctly, please contact an EXPERT or a specialist
workshop and let them carry out the installation.
In case of improper installation, the product as well as your computer and all connected devices will
be damaged.
Lethal Danger!
Switch off the computer in which the product is to be installed and all connected devices and separate all
devices from the mains voltage. Unplug the mains plug! To switch the device off via the ON/OFF switch
is not enough!
1.
Open the housing of your computer and carefully take off the lid of the housing.
2.
Look for a free 3.5" installation slot and remove the respective front cover. There may be a metal shield behind it which needs
to be removed. For some housings it can be screwed off, for some it has to be carefully broken out. Depending on the housing
the complete front cover of the housing has to be removed beforehand.
3.
Push the panel in the 3.5" plug-in unit of your computer housing; firmly screw the panel afterwards.
4.
Connect the cable of the panel with the corresponding connection of your mainboard. In doing so, pay attention to the
information in the mainboard manufacturer's instructions.
5.
Lay the cable in a way so that it cannot get into a fan of the PC, to fasten it use, e.g. a cable fastener (not included).
6.
Close the computer case.
7.
Connect your computer and monitor with the mains voltage und switch on all devices.
8.
If your computer does not start correctly, switch it off immediately and check all settings and cable connections.
7.
Card reader
The power / card reader LED shines red when it is ready. It flashes red when reading and recording memory cards. When reading
and recording SIM and smart cards, the LED flashes green.
Inserting/removing cards
•
Insert the memory card into the corresponding slot of the card reader; there is only one correct orientation. Do not use any
force when you are inserting it! Several slots can be used simultaneously, if for example, you wish to transfer data between
the memory cards.
•
If there is any read/write access on the memory card, wait until it is finished. Only then remove the memory card. If the
memory card is pulled out during a read/write access, the data on the memory card may get damaged, and it may even be
necessary to reformat the memory card.
Reading/Writing of cards
•
Each plug-in unit of the card reader is integrated like a normal removable medium drive. Windows automatically allocates
additional drive letters.
•
You can now read the data on the memory cards in File Explorer (or record data on the memory cards) as you do with hard
discs or floppy drives.
8.
Remote control
The remote control is compatible with the Windows Media Center Edition (MCE) application. You can get more detailed information
on the functions of Windows MCE and control via remote control on the Internet at www.microsoft.com.
9.
Disposal
Dispose of waste electrical and electronic equipment
In order to preserve, protect and improve the quality of environment, protect human health and utilise natural
resources prudently and rationally, the user should return unserviceable product to relevant facilities in accordance
with statutory regulations.
The crossed-out wheeled bin indicates the product needs to be disposed separately and not as municipal waste.
Used batteries/ rechargeable batteries disposal
The user is legally obliged (battery regulation) to return used batteries and rechargeable batteries. Disposing
used batteries in the household waste is prohibited! Batteries/ rechargeable batteries containing hazardous
substances are marked with the crossed-out wheeled bin. The symbol indicates that the product is forbidden to
be disposed via the domestic refuse. The chemical symbols for the respective hazardous substances are Cd =
Cadmium, Hg = Mercury, Pb = Lead.
You can return used batteries/ rechargeable batteries free of charge to any collecting point of your local authority, our
stores or where batteries/ rechargeable batteries are sold.
Consequently you comply with your legal obligations and contribute to environmental protection!
10.
Technical data
Supported card formats:
SmartCard slot: Smart Card
SIM slot: SIM card
xD 1.21 slot: x-picture / x-picture 1.21 / SM / SM ROM
SD/mini SD/MMC/RS&4.2 slot: SD / Mini SD / HS Mini SD / Extreme SD / Extreme III SD /
Ultra SD / Ultra II SD / Ultra II SD Plus / SD-Ultra-X / Ultra Speed SD / SD Pro / SDHC / SD
Elite Pro / HS SD / MMC / MMC 4.0 / HS MMC / HS RS MMC / RS MMC / RS MMC 4.0 /
MMC Mobile / MMC Plus / MMC 4.2
micro SD slot: micro SD
M2 slot: M2
CFI/CFII slot: CF I / CF II / CF 3.0 / Extreme III CF / Extreme CF / Ultra II CF / HS CF / XS-XS
CF / CF Elite Pro / CF Pro / CF Pro II / CF4.0 / IBM MD / Hitachi MD / Magic Stor MD
MS/MS PRO DUO slot: MS / MS Pro / MS Duo / MS Pro Duo / MS MG Pro / MS MG / MS MG
Duo / MS MG Pro Duo / Extreme MS Pro / MS Select / Extreme III MS Pro / Ultra II MS Pro /
HS MS MG Pro / HS MS MG Pro Duo / HS MS Pro / HS MS Pro Duo / MS ROM / MS HG
Front connection:
USB 2.0
Operating systems:
Memory Card: Windows ® ME / XP / Vista™ / Mac 10.4.5 / Linux Fedora Core 5
SIM-Card / Smart Card: Windows ® ME / XP / Vista™
Weight (card reader):
220 g
Operating voltage
3 V/DC (2x battery type AAA, not included in delivery content)
remote control:
These operating instructions are published by Conrad Electronic SE,
Klaus-Conrad-Straße 1, D-92240 Hirschau/Germany.
The operating instructions reflect the current technical specifications at time of print.
We reserve the right to change the technical or physical specifications.
© 2009 by Conrad Electronic SE.
*02_02/09_01-SB
Werbung
Inhaltsverzeichnis
