Werbung
Verfügbare Sprachen
Verfügbare Sprachen
S3211
General Safety
Please read, understand and obey all information and warning notices within this manual
before using the tool for the first time. Disregarding may lead to injuries and/or physical
damages and revokes the guarantee.
1. This air hammer is a part of a high pressure system. Do not exceed maximum
operating pressure of the air tool ( 90 PSI – 6,2 bar ). The hammer could explode
and result in death or serious injury.
2. Disconnect the air drill from air compressor before changing tools or accessories,
servicing and during nonoperation.
3. Always wear safety glasses and use hearing protection during operation.
4. Do not wear loose fitting clothing and jewelry which may become caught in moving
parts and result in serious injury.
5. Do not depress trigger when connecting the air hose.
6. Never trigger the tool when not applied to a work object. Accessories must be
securely attached.
7. Make sure spring retainer and all connections are secure and check air hoses for
weak or worn condition before each use.
8. WARNING !!! Disconnect air supply before installing or any maintenance.
Maintenance Tips
This air hammer requires lubrication BEFORE initial use and BEFORE and AFTER each
additional use throughout its life.
1. WARNING !!! Disconnect the air hammer from the air supply and hold the tool upside
down.
2. Pull the trigger, put a half teaspoon of air tool oil into the air inlet.
3. Reconnect the air hammer to the air supply and run the hammer for 20 seconds.
Cover the exhaust port with a towel and run for 20 seconds. Oil will discharge from
the rear exhaust port when air pressure is applied. Any excess oil in the motor is
immediately expelled from the exhaust port.
WARNING !!! Always direct exhaust port away from people or objects.
SW-Stahl GmbH
Leverkuser Straße 65
D-42897 Remscheid
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
www.swstahl.de
Werbung
