Buffalo HD-QLU3R5 Benutzerhandbuch Seite 34

One or both of
the access LEDs is
blinking red
Both access LEDs
are glowing red
An access LED is
completely off
The corresponding access LED blinks green when a drive is being accessed. During RAID maintenance,
the power LED glows purple.
A rebuild is in progress. Normally this happens after a
hard drive is replaced in a RAID 5, RAID 10, or RAID 1 array.
Do not turn off the power until rebuilding is complete.
When rebuilding is complete, the unit will beep three
times and the access LED will glow a steady green (not
blinking). During the rebuild, turning off the power can
(Short beeps) damage the unit or corrupt data.
Connection to a computer is still possible during
rebuilding, but the data transfer speed will be slower.
The rebuilding time takes about 21 minutes per 100 GB
(for the HD-QL4TU3R5, about 210 minutes in RAID 5 mode
and about 420 minutes in RAID 10 mode). (This is an
estimated time with no computer connected.)
Beep for about
The DriveStation is not recognized. Check the USB cable
three seconds and
connecting the DriveStation to your computer.
stops
The hard drive is not connected correctly. Make sure that
－
the drives are firmly seated inside the DriveStation.
HD-QLU3 User Manual
33