Technical Data; Maintenance And Cleaning - Conrad 1194440 Bedienungsanleitung

c) Filling the water tank
Tank cover Water tank
Rinse the water tank of the air humidifier thoroughly with clean, cold water before using for
the first time.
1. Carefully pull the water tank out a little from the back of the USB humidifier and remove the tank cover.
2. Do not remove the tank completely, as you could damage the pump cable and tube.
3. Fill the tank with 30 ml to a maximum of 120 ml of water; do not fill the tank higher than the "MAX" mark.
Only use fresh tap water that does not contain other additives to fill the water tank.
4. Change the water daily to prevent the formation of mould and unpleasant odours.
Operation
1. Place the USB air humidifier on a stable, flat and water resistant surface of a sufficient size.
2. Position the USB air humidifier approximately 50-70 cm from the object or part of a room to be ventilated/
humidified.
Direct the air flow of the fan in the desired direction.
3. Press the POWER button (1) to turn the USB air humidifier on/off. Optionally, you may use the
DOWN (2) or UP button (3) to turn the unit on.
4. Press the DOWN button (2) to lower the fan speed of the USB air humidifier.
5. Press the UP button (3) to increase the fan speed of the USB air humidifier.
6. Press the WATER button (5) to turn the water evaporation function on the USB air humidifier on/off.
The blue LED illuminates when the water evaporation function is turned on.
Do not turn the water evaporation function on when the water level in the tank drops below
30 ml. Using this function for extended periods when the tank is empty can destroy the pump.

Maintenance and cleaning

a) Changing the evaporation filter
Replace the evaporation filter when it is damaged and contaminated with large particles or
when it smells unpleasant.
1. Carefully remove the air inlet grill from the USB air humidifier.
2. Carefully remove the dirty/used evaporation filter.
3. Insert a new evaporation filter; ensure that the filter is inserted in the correct position. The darkly-coloured
plastic mesh must face up.
Keep the evaporation filter dry when you are not using the USB air humidifier.
b) Cleaning
• Begin by disconnecting the USB air humidifier from the power supply - remove the low-voltage connector
from the socket on the humidifier.
• Maintenance or repair may only be carried out by a qualified technician or service centre. Under no
circumstances must components in the interior of the device be serviced by you. For this reason, never
open or dismantle these components.
• The device can be cleaned with a dry, soft and clean cloth. Do not press too hard on the device housing;
this can cause scratches.
• Dust can be easily removed using a long-haired. soft and clean brush and a vacuum cleaner.
• Do not clean the USB air humidifier and/or components in the dishwasher.
• Never use abrasive cleaning materials, rubbing alcohol or other chemical solutions, as these can corrode
the housing or even impair the normal functioning of the device.
Disposal
a) Product
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product according to the relevant statutory regulations.
Remove any inserted (rechargeable) batteries and dispose of them separately from the product.
b) (Rechargeable) batteries
You as the end user are required by law (Battery Ordinance) to return all used batteries/rechargeable
batteries. Disposing of them in the household waste is prohibited.
Contaminated (rechargeable) batteries are labelled with this symbol to indicate that disposal
in the domestic waste is forbidden. The designations for the heavy metals involved are: Cd =
Cadmium, Hg = Mercury, Pb = Lead (name on (rechargeable) batteries, e.g. below the trash
icon on the left).
Used (rechargeable) batteries can be returned to collection points in your municipality, our stores
or wherever (rechargeable) batteries are sold.
You thus fulfil your statutory obligations and contribute to the protection of the environment.

Technical data

a) Product
Operating voltage ................... 5 V/DC (via USB)
Current consumption .............. 500 mA
Noise level .............................. ≤50 dB
Cooling area ........................... 200 cm²
Water fill amount ..................... 30 -120 ml
Operating conditions ............... -10 to +45 °C, 0 - 85 % RH (non-condensing)
Storage conditions .................. -10 to +45 °C, 0 - 95 % RH (non-condensing)
Dimensions (W x H x D) ......... 87 x 265 x 100 mm
USB cable length .................... approx. 100 cm
Weight .................................... 484 g
b) Batteries
Battery operation .................... 4 x 1.5 V AAA batteries
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
(www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited. This publication represent the technical status at the time of
printing.
© Copyright 2014 by Conrad Electronic SE. V2_1214_02_JH