Installation And Setup; Setting Up The Player; Dvd Player Connections; Video And Audio Connections To Your Tv - LG DV9800H Gebrauchsanleitung

Installation and Setup

Setting up the Player

The picture and sound of a nearby TV, VCR, or radio
may be distorted during playback. If this occurs,
position the player away from the TV, VCR, or radio,
or turn off the unit after removing the disc.

DVD Player Connections

Depending on your TV and other equipment there are
various ways you can connect the player. Please refer
to the manuals of your TV, stereo system or other
devices as necessary for additional connection
information.
Rear of TV
COMPONENT VIDEO /
AUDIO INPUT
PROGRESSIVE SCAN INPUT
Pr Pb Y
R L
C A
Caution:
You must set the TV Output Select option to use
COMPONENT VIDEO OUT/ (576p / 720p / 1080i)
and SCART jacks.
(See "TV Output Select" on page 14.)

Video and Audio Connections to Your TV

Make sure the DVD player is connected directly to the
TV and not to a VCR, otherwise the DVD image could
be distorted by the copy protection system.
Audio: Connect the left and right AUDIO OUT
jacks of the DVD Player to the audio left and right
IN jacks on the TV (A) using the audio cables.
Do not connect the DVD Player's AUDIO OUT jack
to the phone in jack (record deck) of your audio
system.
SCART INPUT
VIDEO
INPUT
V T
Rear of DVD player
Video: Connect the VIDEO OUT jack on the DVD
player to the video in jack on the TV using the
video cable (V).
S-Video: Connect the S-VIDEO OUT jack on the
DVD Player to the S-Video in jack on the TV using
the S-Video cable (S)
SCART connection: Connect the TO TV scart jack
on the DVD Player to the corresponding in jacks on
the TV using the scart cable (T).
Component Video : Connect the COMPONENT
VIDEO OUT / (576p / 720p / 1080i) jacks on the
DVD Player to the corresponding in jacks on the
TV using an Y Pb Pr cable (C).
• If your television is a high-definition or
"digital ready" television, you may take
advantage of displaying the highest video
resolution possible.
• If your TV does not accept your resolution
setting, abnormal picture appears on the screen.
Please read TV's owner's manual then set the
resolution that your TV can accept.
Resolution setting
You can change the resolution for the COMPONENT
VIDEO OUT / (576p / 720p / 1080i) video output by
pressing RESOLUTION on the front panel. Available
resolution settings are as shown below.
OUTPUT Available Resolution
CONNECTION
PAL
HDMI 1920 x 1080i
VIDEO OUT 1280 x 720p
720 x 576p
1440 x 576i
1920 x 1080i
COMPONENT 1280 x 720p
VIDEO OUT 720 x 576p
720 x 576i
VIDEO OUT 720 x 576i
S-VIDEO 720 x 576i
SCART 720 x 576i
Notes:
• For 720p and 1080i resolution on the component
video out, only non-copy protected discs can be
played back. If the disc is copy protected, it will be
displayed at the 576p(PAL) or 480p(NTSC)
resolution.
• 1080i, 720p, 576p and 480p do not work with the
analog video connections (VIDEO OUT, SCART &
S-VIDEO).
NTSC
1920 x 1080i
1280 x 720p
720 x 480p
1440 x 480i
1920 x 1080i
1280 x 720p
720 x 480p
720 x 480i
720 x 480i
720 x 480i
9