Getting Started; Battery Installation Remote Control; Battery Installation Receiver/ Driver - Jasno Rf Ms3 Gebrauchsanleitung

Getting started

Battery installation remote control
The RF remote control requires 2 pieces of AAA Alkaline batteries 1.5V.
To install the batteries, turn over the remote and open the cover. Insert the
batteries matching the (+) and (-) marks and cover the bottom cover. If the
battery has been properly installed, the light stripe will light up.
Remote Control
Back Cover
Battery installation receiver/ driver
The order in which batteries are installed in the receiver / driver affects how
your shutters are programmed. Please see "Programming Instructions"
for details. To install batteries, open the battery cover and remove the
battery cartridge. Insert 6 pieces AA Alkaline batteries 1.5V (for solar use
rechargeable!) matching the (+) and (-) marks inside the battery cartridge.
Put back the cartridge and reinstall the battery cover.
Receiver / driver
22
Battery cover Battery cartridge
Blue light stripe
Pole marks
(+) and (-)