Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
d) Achieving target values
• If you have programmed a target value when you carried out the settings for the device (see
"Settings"), a graphic display for the progress of the training will appear on the left side of the
display.
• When the set target value is reached, the display fl ashes and a signal is emitted.
The target value was pre-set by the factory to 5,000 steps per day. However, this
value can be set to "0" in the settings menu in order to no longer use this function.
e) Reset
There are three reset types: reset the data for the current day, reset the total memory and reset
to factory settings.
• In the display of the data for the current day, press the RESET (3) key for two seconds, to
delete the data for the current day.
• In the display of the total memory, press the RESET (3) key for two seconds, to completely
delete all measured data.
• Press the RESET key on the back of the housing using a pointed object (e.g. a straightened
paper clip) to reset the device to the factory settings. This will also delete your personal data
such as step length, body weight etc.
The data for the current day will be reset automatically at midnight. However, they
are still stored in the memory for the last 30 days.
Should there be no data recordings for one day, the corresponding day will be saved
nonetheless. In this case, the corresponding data will display "0".
The oldest data will be overwritten after 30 days so that the memory always contains
the last 30 days.
Replacing the batteries
Batteries/rechargeable batteries must be kept out of the reach of children.
Do not leave batteries lying around in the open; there is a risk of them being
swallowed by children or domestic animals. If they are swallowed, consult a
doctor immediately.
Leaking or damaged batteries can cause burns if they come into contact with
the skin. You should therefore wear suitable protective gloves.
Batteries/rechargeable batteries must not be short-circuited, opened or
thrown into a fi re. There is a risk of explosion!
Do not recharge normal, non-rechargeable batteries; there is a risk of explo-
sion!
Please pay attention to the correct polarity (plus/+ and minus/-) when inserting
the battery.
Remove batteries from the device if you do not require it for a longer period.
• If the display contrast fades or the device no longer works, the battery has to be replaced.
• To this end, unfasten the battery compartment screw at the back of the unit.
• Remove the battery compartment lid and replace the battery by an equivalent coin cell of the
type CR2032. The positive pole must point outwards (see image).
• Replace the battery compartment lid and screw it back on.
During the battery replacement all data will be deleted.
Connecting a computer
• Before connecting to a computer, you must install the software and the driver on your com-
puter.
• To do this, download the software package from our webpage. You can fi nd it on the product
page for the step counter in the section "Documents and Downloads".
• Install the software as described in the software instructions. The software instructions can
also be found on our webpage.
• Open the cover of the USB interface on the step counter and insert the USB cable provided.
• Connect the other end of the USB cable to a suitable USB port on your computer.
• Start the software and continue as described in the software instructions.
Compatible operating systems:
Windows XP, Windows Vista, Windows 7 and Windows 8
Maintenance and Care
Apart from replacing the batteries, the product does not require any maintenance and should
never be disassembled.
Please use a soft, dry, clean cloth for cleaning.
Do not use any chemical cleaning agents, as they can discolour the plastic casing.
Disposal
Electronic devices are recyclable waste materials and must not be disposed of in the
household waste!
Dispose of an unserviceable product in accordance with the relevant statutory regu-
lations at the end of its life.
Remove the battery if there is one inserted and dispose of it separately from the
product.
Disposal of batteries and rechargeable batteries
As the end user, you are required by law (Battery Regulation) to return used batteries and
rechargeable batteries. Do not dispose of used batteries in the household waste!
Batteries/rechargeable batteries contain harmful materials and are labelled with
the symbol shown to indicate that disposal in the household waste is forbidden.
The symbols of the relevant heavy metals are: Cd=cadmium, Hg=mercury, Pb=lead
(marking can be seen on the battery/rechargeable battery, e.g. underneath the
refuse bin symbol shown on the left).
You can return your used batteries/rechargeable batteries free of charge at the offi cial col-
lection points of your community, in our stores, or at places where batteries or rechargeable
batteries are sold!
You thereby fulfi l your statutory obligations and contribute to the protection of the environment.
Technical Data
Operating voltage ................. 3 V/DC
Battery .................................. 3 V lithium coin cell CR2032
Battery service life ................ approx. 1 year (depending on usage frequency)
Training memor..................... 30 days
Adjustable step length .......... 30-213 cm
..............................................
Body weight 20-226 kg
Dimensions ........................... 77.5 x 34 x 11.5 mm (without mounting clip)
Weight .................................. 35 g (with mounting clip and battery)
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfi lming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2013 by Conrad Electronic SE.
Werbung
Inhaltsverzeichnis
