Synchronising The Controller With The Remote Transmitter - Carson DRAGSTER PRO Betriebsanleitung

2. Synchronising the controller with the
remote transmitter
• Switch on the transmitter.
• Connect the controller to the power supply.
• Hold down the SET button and switch the controller on at the
on / off switch; you will hear a beep.
The blue LED lights up.
GB
• Set the throttle / brake lever to the full acceleration position.
The red and yellow LED lamps fl ash briefl y and then remain
illuminated. You will hear a beep.
The full throttle setting is stored.
• Return the throttle / brake lever fully.
The yellow and blue LED lamps fl ash briefl y and then remain
illuminated. You will hear two beeps.
The brake setting is stored.
• Put the throttle / brake lever to neutral.
The red and green LED lamps fl ash briefl y and then remain
illuminated. You will hear three beeps.
• The synchronization is complete, all LEDs are out.
• Switch the controller off.
When you switch the controller on again, the speed controller is
synchronized to the transmitter and is fundamentally ready for use.
If your RC car goes backwards when you activate
the transmitter to accelerate forwards, swap 2 of 3 cables
8 CARSON DRAGSTER Brushless-Regler 906008+906056
to the motor.