IDEAL 33-772 Handbuch

IE Net PRO Cable Tester
Eight modes of operation
1. DATA – cable test mode
2. COAX (RJ45) – cable test mode
3. LENGTH – Cable length measure
4. TONE
Press MODE to select any of the seven modes of operation, press SELECT to
enter selected operation mode and proceed,
Press SELECT for two seconds to turn backlight on/off.
DATA – Data Cable Test
1. Press any of the four keys to power on
the tester; when powered on, M12,
M12>RJ45, RJ45 shows on the first
line of the screen;
2. M12 is the default setting; use Up or
Down arrow keys to select M12>RJ45
or RJ45
M12– for 2-pair data cable test
When in M12 mode and no cable is
connected, the display shows:
1. When in M12 mode "No shield" is
default setting
2. Exit to SETUP to change options
(see Set Up mode)
3. When using M12 mode, the Split Pair
function is automatically disabled.
Standby - Cable Test (Pre-Test)
1. When in M12 mode,
2. Connect cable to the Tester (see
following screens for more
demonstrations )
Note: When there is no Remote
connected, Shield and No Shield will
not appear)
5. HUB BLINK
6. Set up Mode
7. OFF
8. Voltage Protection
M12
to change type
MODE=ESC, SEL=go
Test M12
1234
Open 1-3 2-4
Displays and cycling in sequential order
1-3, 2-4, No Cable
Test M12
12 34
Pass Pre-Test
15.5 ft
Cycling in sequential order
1 2, 3 4
M12>RJ45
33-772
RJ45