Werbung
Verfügbare Sprachen
Verfügbare Sprachen
En
Preface
The directions for use is divided into chapters which all contain important information about the electrical sit and
stand table. Read the directions for use carefully before starting usage of the table.
Table of content
1.
Security precautions
2.
Usage
3.
Set up and installation
4.
Operation
5.
Maintenance and defect
6.
Technical data
7.
Warranty and service
8.
Assembly directions
1.
Security precautions
IMPORTANT NOTICE - Read carefully before use.
•
Do not raise or lower the table if people are sitting underneath it.
•
Place the table in a safe distance from window frames, radiators, furniture etc. so that people do not get stuck.
•
Do not place any objects above 60 cm underneath the table.
•
Do not use the table to raise or lower people.
•
When moving the table after it has been assembled, the table top needs to be removed. The table CANNOT
be lifted by the tabletop.
2. Usage
The table can be used indoor as computer workstation; for hobbies like sewing or model assembly etc.
Please note that sharp and hot objects can damage the table top.
3.
Set up and installation
When the table has been assembled (see assembly instructions on page 7-8) the adjustable feet are installed so
that the table is level and does not shift.
Then the table is connected to the outlet and the table is ready for use.
4.
Operation
When the table has been assembled, installed and put in its location the raising and
lowering features can be used.
This is done by activating the 0-1 rocker switch and pushing the other switch in ether
left or right direction. The table will stop mowing when you release contact with the
switch.
5. Maintenance and defects
The table does not require any maintenance by usage as described in chapter 2 in the directions for use.
By defects in the raising and lowering functions, the dealer NEEDS to be contacted. To locate the closest dealer
please call: +45 9680 0080 or e-mail: conset@conset.com.
3
8
Werbung
