Operation - Mathmos Space projector Gebrauchsanleitung

The Spate Projector is a CLASS Ill Electrical Product (12V SELV) connected to a class 11
lt has passed the relevant safety Standards and carries the statutory guarantee of the country of purchase.
The Spate Projector is not intended for use by children.
PLEASE READ ALL THE INSTRUCTIONS BEFORE FIRST USE AND RETAIN FOR FUTURE REFERENCE.
Slide Camer Slot
Slide Carrier & Slide
Projector Bodv
Unpack projector and place upright on a stable surface.
Unpack the oil wheel and insert into the Oil wheel slot.
Plug in at the socket and switch on.
DO NOT: block the Ventilation Slots in the transformer.
DO NOT: place on carpets or block the Ventilation spaces in the projector base.
.
insert the oil wheel into the correct side of the projector body as shown.
insert the oil wheel until a Iight click is felt and the oil wheel is central in the projector.
DO: place the transformer on its feet.
q
Angle the projector body to Point at the wall or ceiling.
The best effect is achieved on a white surface.
The brightness and size of image are controlled by the amount of light in the room and the distance
from the Wall.
The effect will Change as the oil wheel warms up. lt is normal for the oil wheel to get hot.
DO NOT: look directly into focusing lens.
DO NOT: leave unattended with small children.
DO NOT: use for more than six hours in any one Session.
DO NOT: Shake the oil wheel.
. .
use only when fitted to its base and placed on a level sutface, (any other orientation will
DO: unplug the transformer from the mains socket when not in continous use.
Other effects are possible by obtaining Mathmos Spate Projector upgrade Packs from your Mathmos
stockist.
The slide carrier is for use with these Packs and when not in use tan be stored in the slide carrier slot.
To view the promotional slide; remove the oil wheel and insert the slide carrier with promotional slide
into the slide carrier slot as shown, and re focus.
DO NOT: attempt to use Standard photographic slides in the Spate Projector.
DO: use only Mathmos Spate Projector effects and accessories.
BULB NOT WORKING
Should the bulb not light, first check that the plug fuse is working (where fitted), if not
replace with a 3A fuse.
Should the Problem persist, contact your nearest Mathmos dealer.
TO CHANGE THE BULB
DO:
use only a 2OW12V IO" DICHROIC CLOSED FRONT 35MM DIAMETER.
DO:
unplug the projector from the wall socket and allow to cool before bulb Change.
Bulbs should be available from your Mathmos stockist.
Remove the oil wheel and slide carrier if in use.
Hold the projector upside down so you are looking into the base, centre fhe Clips and
release by gently pulling the base slot apart, do not try to squeeze the Clips together.
Oil Wheel Slot
Oil Wheel
Transformer
in Projector