Mathmos Space projector Gebrauchsanleitung Seite 4

Remove the 6 casing screws.
Lift off the back case and remove the focusing lens.
off the bulb connector and unscrew the 2 bulb clamp screws.
(MUST be in plac
Replace the bulb and refit the bulb clamp screws taking care not to over tighten.
Gently push the bulb connector onto the bulb Pins.
Refit the 6 casing screws taking care not to over tighten.
Clip the projector body back into the base.
.
use the correct size crosshead screwdriver.
take care not to mix
(bulb clamp screws are shorter).
unplug the projector from the wall socket and allow to cool before cleaning.
DO:
Use a damp cloth to remove any marks on the outer casing of this product.
Clean the lenses with a lens cloth.
Take care not to get finger marks on the lens.
.
the bulb clamp screws and the casing screws