INSECT-O-CUTOR PRISM Anleitung Seite 4

The discreet solution to a fly free home
Tube replacement
To ensure the efficiency of PRISM™ in catching flying
insects, the UV tube should be replaced annually. After
twelve months the phosphor coating that emits the
correct wavelength of UV light has burnt away and the
UV output is diminished substantially.
To replace the UV tube:
1. Ensure the unit is disconnected from the power supply.
2. Remove the glueboard.
3. Holding the tube firmly, but with care, hold the unit
with one hand and with the other hand gently pull the
tube from the tube holder until it unclips. Do not twist the
tube.
4. Fit the new tube by aligning it with the tube holder
and push gently into position.
5. Replace the glueboard and reconnect the unit to the
power supply.
6. Dispose of the used UV tube in conjunction with local
WEEE regulations.
Always ensure that the tube used is a genuine Philips UV
tube.
SPECIFICATION / REPLACEMENT PARTS
Unit
Voltage
Dimensions(mm) 250 x 150 x 90
Coverage
Weight
Light Output
Tubes
Glueboards (x6)
R1 12/16
PRISM ™
230V ~ 50Hz
30m
2
0.64 Kg
11W
1 x TPX11
INL212
Sterling House T +44 (0)800 988 5359
Grimbald Crag Close F +44 (0)1423 863 497
Knaresborough W www.pelsis.com
North Yorkshire E info@pelsis.com
HG5 8PJ UK
Removal
Fitting
WEEE Compliance No. WEE/GF0661QR
Information provided on these instructions is modified
and updated from time to time.
constant redevelopment of our products. As such, it is
not intended that you should rely on it or that it should
form part of any contract.
Pelsis Ltd
This is due to the
2017
C