Chal-Tec Auna IR-130 Bedienungsanleitung Seite 16

Those steps for connecting your radio to your network.
Step 1 Switching on the radio
Plug the cable from the AC adapter into the socket labeled DC on the back of the radio, then power on the
radio.
Caution: Use only the mains adapter supplied with the radio. Connecting a power supply with a different
rating will cause permanent damage to the radio and may be hazardous.
The display on the front of the radio will light up and say:
Then show
After a few seconds, it will shows :
I. If select "Yes", it will auto scan the ESSID as
Then it will list all the ESSID names it can find, you can select one of you want to use, maybe it will request
you input the correct WEP(Wired Equivalent Privacy) or WPA(Wi-Fi Protected Access) code. If your network
is not configured to need a WEP or a WPA code, the unit will connect to the ESSID auto and success as
Or if you are requested to input the encryption, you can do as below
1. Select the one you want to use
2. Then it will show you
Note: The encryption code would have been set up by the person who set up and configured your network.
After 3 seconds the display goes into the code entry mode or press "enter".
Please refer to the 1.2.5 to know clear of the "Remote control character list" for you to enter the passwords.
Dial the volume/select to show the code you want, press "→" button to go to the next word, press "←"
button to delete the wrong word you have entered.
3. If you complete the key then you can press "volume/select" to confirm, or use "Enter" of
remote control to confirm. The display shows "Connect WiFI" as the radio connects to the
network.
4. If the connecting is OK, it will show you
SETTING UP