Switching Your Highway On For The First Time; Switching Your Highway On And Off - PURE Highway 600 Bedienungsanleitung

Switching your Highway on for the first time

After you've installed your Highway, switch it on to finish setting it up.
1. Turn on your vehicle's ignition to make sure the antenna is switched on. After a few seconds, the wireless controller automatically
connects to the antenna. If not, see page 21.
2. Turn the Select dial to change the display language, then press the Select dial to choose it.
3. Turn and press the Select dial to choose how to connect your Highway to your vehicle.
• If you've connected your Highway with an auxiliary cable, choose 'LINE OUT'.
• If you're connecting your Highway by FM radio, choose 'FM TRANSMIT' and then choose an FM frequency. Ensure a radio
station isn't using the frequency you choose.
Tune your vehicle's audio system to the same FM frequency your Highway. To easily find the FM frequency in the
future, save it as a preset on your vehicle's audio system.
After you've chosen how to connect your Highway, it starts tuning to digital radio stations. When the autotune is complete, you can
start listening to digital radio.

Switching your Highway on and off

• To switch on your Highway, press .
• To put your Highway in standby and use less power, press and hold .
Note: By default, the antenna automatically enters standby after 4 hours, and the screen on the wireless controller dims after
15 seconds. Read more about the display brightness on page 19.
13