Operation - Yard Force GDGS12 Original Bedienungsanleitung

Charging the battery Pack (Fig 7)
NOTE: The battery pack will be fully charged after 70mins. Remove it from the charger after it
has been fully charged.
NOTE: This battery pack has been shipped in a low charge condition. It should be fully charged
before first use.
NOTE: Make sure the main voltage is the same as rating label which located on the charger.
1. Connect the charger to a power supply. The green LED power light comes on, indicating the
charger is ready for use.
2. Align the raised ribs of the battery pack with the slot in the charger. Insert the battery pack into
the charger. The red LED light will come on, and the green LED light will shut off at the same
time, indicating the battery is correctly seated and on charge.
NOTE: If the red LED light doesn't comes on, and the green LED light is still on, the battery
pack is too hot and cannot be charged.
Remove the battery and allow it to cool for 30 minutes and then re-insert it.
3. The battery pack will normally be fully charged after 70 minutes, when the red LED light will shut
off and the green light comes on again. The initial charge may take longer.
4. Remove the battery pack from the charger.
To obtain the best life from the battery
Never allow the battery to completely discharge before recharging. The battery pack should be placed
on the charger whenever the battery pack is noticeably running down or the tool no longer performs a
task it previously performed.
Avoid conducting short charges. Make sure that the battery is fully charged every time by allowing the

OPERATION

Fig.7
Charger
Battery pack
47