Vivanco FSS 21000B IP44 Bedienungsanleitung Seite 2

433,92MHz
< 5dB, ASK
GB
Instruction Manual
IMPORTANT,
READ ATTENTIVELY BEFORE USE!
KEEP FOR REFERENCE
Technical data
Remote control
Range:
conditions
Battery:
Transmission frequency:
Receiver
Voltage:
Max. total load:
Switching capacity
Power consumption:
Protection class:
Protection type:
Declaration of conformity
Hereby Vivanco GmbH declares that the radio equipment type
[article 37671 / FSS 21000B IP44] is in compliance with Directive
2014/53/EU. The full text of the EU declaration of conformity is
available at the following internet address: www.vivanco.de
Proper use
This device has been designed for Indoor and Outdoor use. Please take
care about the correct positioning of the product (see „Instructions to
use). The device must be only connected to a mains socket with earth
contact. For outdoor use the mains socket and the connected devices
and cables must at least comply with protection class IP44.
Content
2 Radio mains socket receiver, 1 Remote control, 1 Battery (CR2032, 3V)
1 User manual
Safety instructions
Danger of life by electrocution
• The device is to be used on household power outlets with voltage,
power and frequency values according to the specifications on the
label of the device.
• Please do not use the device, if it appears to be damaged.
• Do not use the device under high temperatures, do not cover it
and make sure of sufficient ventilation.
• This device is protected according to IP44, it can be used outdoors.
Take care about the correct operating position!
• Connect only to a properly grounded electrical outlet. Outdoor it must
be IP44 compliant.
• Never use the product in or uder water
• Never use the product when your hands are wet or damp.
• Avoid the overloading of the device. In case of overloading a fire
hazard or a damage on the device can occurr. the maximal load is
of 1.000 W per radio plug.
• Do not connect the plugs serially.
• Spannungsfrei nur bei gezogenem Stecker
• To prevent electric shocks, do not open the device. Professionals
may only carry out repairs.
• Absolutely unplug the device before cleaning it. in this case,
disconnect the radio plug from the wall plug and all power plugs
from the device.
• In the event of a fault, immediately switch off the device.
Risk of Injury by wrong handling/storage of batteries
• Only use admitted batteries to avoid explosion hazard (see technical
data)
• Keep batteries away from the reach of children.
• Batteries must not get in touch with metal surfaces and coins.
The battery could short-circuit, discharge, getting hot or leak.
• Do not split batteries, do not insert them in the wrong direction.
Do not expose batteries to liquids, humidity, fire or extreme
temperatures.
• Remove batteries, if you do not use the product for a long time.
• If battery liquid gets in touch with your skin, wash it immediately
with water, and contact a physician.
• Dispose batteries according to the prescription of the competent
authority.
• Do not load non-rechargeable batteries.
up to approx. 25m under optimal
CR2032, 3V
433,92MHz
230V~ / 50Hz
4,35A / 1.000W
max. 1.000W
< 1W
I
IP44
Installation and operation
Remote Control Preparation
Open the battery compartment on the rear side of the radio remote
control. Insert 3V-batteries by complying with the right polarity. Then
close the battery compartment. By pressing the key you can check if the
radio remote control works; if yes, the operational LED lights up if you
press the key.
Connection of the Remote Control Plug-In Receiver
1. Take the remote control plug-in receiver and connect it to a correcly
earthed wall plug.
2. Press within 30 seconds the ON button on the remote control, with
which you would like to control your receiver.
Example: You will press button A.
3. You will hear at the receiver a „click" sound. Pairing is complete and
you can switch ON/OFF the receiver with the selected button on your
remote control.
4. Repeat step 1 - 3 for all receivers which you would like to switch ON/OFF.
Delete Programming
1. Manually connect the receiver whose programming you have to delete.
Insert it correctly into the earthed wall plug.
2. Please check with which button the receiver will be controlled.
3. Remove the receiver from the mains socket. After 5 seconds, connect
the receiver to the mains socket. Press within 30 seconds the OFF
button on the remote control, from which you would like to delete the
pairing.
4. The pairing of the receiver and the selected remote control button is
now deleted. If you have used several buttons, please repeat step 1 - 3.
Operation
1. Wireless sockets can only be used on freely accesible and visible
shockproof sockets. Insert the wireless socket in the correct position
into the mains power socket (see picture) and connect the respective
consumer.
2. Switch a user appliance on. The remote plug can only take the
switching function if the appliance to be switched is switched on.
ATTENTION! FIRE HAZARD!
Do not connect appliances whose switching-on can cause fire or other
damages. Overloading can cause fire or damages of the appliance.
3. Activate the ON/OFF key for the channel (A/B/C/B) whose user you
would like to switch on/off.
Cleaning
No liquids can enter the internal parts of the appliance. To clean the box
use a soft cloth. Do never use binzine, thinner or detergents aggressive
towards the plastic. Before cleaning always disconnect the radio plug
from the wall plug and all power plugs from the appliance.
Disposal of the device
This device shall not be disposed with household waste.
Please hand it over to any collection point for electric devices in
your community or district.
Disposal of battery
Batteries are not to be diposed with household waste. They
can contain toxic heavy metals and are subject to hazardous
waste treatment. Therefore bring used batteries to the municipal
collection point.
Disposal of packing
Packing material shall be recycled.
Please do not dispose with household waste and act according to
local disposal regulations.
37671 / FSS 21000B IP44
Version-No. 1.0
Vivanco UK Ltd.
960 Capability Green
Bedfordshire
LU1 3PE LUTON
www.vivanco.com