GEV LLS 19317 Anleitung Seite 6

LED floodlight with motion detector
LED floodlight
By purchasing this item, you have chosen a high-quality GEV
product. Please read these operating instructions carefully to
ensure correct operation. Keep these instructions in a safe
place so that you can refer back to them if necessary.
Operation
LED floodlight with motion detector
The LED floodlight with motion detector functions using passive
infrared technology. If the motion detector's PIR sensor detects
a moving heat source in its field of detection, it switches on
automatically. Static heat sources do not activate the motion
detector. The adjustable twilight switch can be set to ensure that
the motion detector will operate either during the day and night
or only when it is dark. When movement is detected, the motion
detector switches on the LED and then switches it off again
between approx. 5 seconds and approx. 5 minutes after the last
movement is detected, depending on the setting.
Safety instructions
This device must be installed by a technician, in
accordance with the applicable regulations. The electrical
power supply and the circuit protection must be switched
off during the entire installation process. Please check
that the connection cable is disconnected!
Under no circumstances does the warranty cover damage resulting
from failure to observe these instructions. Nor do we accept liability
for any indirect damage.
Similarly, we can accept no liability for any material damage or
bodily injury caused by mishandling or failure to observe the safety
instructions. No warranty claim may be made in these cases.
In addition, for safety and compliance reasons, you are not
authorised to dismantle or alter the device in any way.
Mounting position
LED floodlight with motion detector
Motion detection is maximised when you move at an angle to the
motion detector. Therefore, the motion detector should always be
installed in a position that ensures that you do not move directly
towards the device.
Installation
Install the light as shown in Figs. B to D. Connect the mains
connection cable as shown in the wiring diagram (Fig. D).
Settings
LED floodlight with motion detector (Fig. E)
SENS sets the range of detection
TIME sets the ON period to between approx. 5 s and 5 min
LUX adjusts the twilight switch to between approx. 4 and
1,000 lux
The motion detector can be adjusted horizontally (Fig. F) and
vertically (Fig. G). To do this, simply undo the screws (G1), adjust
the detector (G2) and then retighten the screws (G3).
Adjust the LED floodlight to the required position and then tighten
the nuts (Fig. B1).
Recycling instructions
This device may not be disposed of with unsorted household
waste. Owners of old devices are required by law to dispose
of this device correctly. Contact your town council for further
information.
6