Safety Instructions; Proper Use - Ergo tools Pattfield E-HW 1139 Bedienungsanleitung

Anleitung E-HW 1139_SPK7:Anl HWK 1500 N-N SPK1
GB

1. Safety instructions

This equipment is not designed to be used by
people (including children) with limited physical,
sensory or mental capacities or those with no
experience and/or knowledge unless they are
supervised by a person who is responsible for
their safety or they have received instructions
from such a person in how to use the equipment
safely. Children must always be supervised in
order to ensure that they do not play with the
equipment.
Please read these directions for use carefully
and note their instructions. Use these directions
for use to learn about the appliance, its correct
use and essential safety precautions.
Take suitable action to keep children away from
the appliance.
The user is responsible for the safety of third
parties within the appliance's radius of action.
Before starting up the appliance, have a
specialist check that the necessary electrical
safeguards are installed.
In stagnant water bodies, garden ponds,
swimming ponds and their surrounding areas the
pump may only be used with an earth-leakage
circuit breaker with an actuating rated current of
up to 30 mA (acc. to VDE 0100 part 702 and
738).
The pump is not designed for use in swimming
pools and paddling pools of any kind or other
bodies of water in which people or animals may
be present during operation.
It is prohibited to operate the pump if a person or
animal is in the danger area.
Ask your electrician!
Carry out a visual inspection each time before
you use the appliance. Never use the appliance
if any of its safety devices are damaged or worn.
Never deactivate any safety devices.
Use the appliance only for the purpose described
in these directions for use.
You are responsible for safety within the
appliance's radius of action.
If the mains cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
Your mains voltage must match the voltage
6
28.05.2009 15:24 Uhr
quoted on the rating plate of the house
waterworks (230 V AC).
Never lift, transport or fasten the house
waterworks by its power cable.
Make sure that the electric plug connections are
positioned where they are safe from flooding and
protected from moisture.
Always pull out the power plug before carrying
out any work on the house waterworks.
Avoid exposing the house waterworks to a direct
water jet.
The user-owner is responsible for observing local
regulations concerning the safety and installation
of equipment. (Ask a qualified electrician if you
are uncertain.)
The user must take suitable precautions (e.g.
installing an alarm system, a reserve pump or
similar) to prevent damage resulting from flooded
rooms caused by faults in the house waterworks.
If the house waterworks fails, have it repaired
only by a qualified electrician or your ISC
Customer Service.
Never allow the house waterworks to run dry and
never operate it with fully closed suction power. If
the house waterworks is damaged due to dry
running, the manufacturer's warranty shall be
cancelled.
The pump must not be used to operate
swimming pools.
The pump must not be installed in the drinking
water pipe line.

2. Proper use

The maximum temperature of the pumped medium
should not exceed +35°C in continuous duty.
It is prohibited to use this pump to convey
combustible, gassing or explosive liquids.
The pumping of aggressive liquids (acids, alkalis, silo
leakage etc.) and liquids containing abrasive
substances (sand) should also be avoided.
Applications
Irrigation and watering of green areas, vegetable
beds and gardens.
Operation of lawn sprinklers.
Drawing of water (with pre-filter) from ponds,
streams, rain barrels, rainwater cisterns and
wells.
Supplying water to the house.
Pumped media
Clear water (fresh water), rain water or mild suds /
service water.
Seite 6