Kompernass E-4575 Bedienungsanleitung Seite 43

Do not use your natural-stone water fountain on a low wa-
ter level. Make sure that the pump will always be covered
by water.
If the water basin has a low water level and the pump is not
completely covered by water while the natural-stone water
fountain is in operation, please unplug the transformer and
fill the water basin with distilled water up to the „MAX" mark
before starting again.
. Adjusting pumping rate and water flow
The pumping rate of the water pump is infinitely variable and
allows to adjust higher or lower water flow when the natural-
stone water fountain is in operation.
To adjust the pumping rate ...

Unplug the transformer.
 Remove the decorative stones from the water basin.
 Carefully take the natural-stone "cascade" body from the
natural-stone bank.
 Take the natural-stone bank with the fixed water pump out
of the water basin.
 You will now be able to adjust the pumping rate with the
rotating switch at the front of the water pump:
• Rotate towards "MIN" for lower pumping rate
• Rotate towards "MAX" for higher pumping rate
 Replace the natural-stone bank and the water pump to their
original position in the water basin. Replace the natural-stone
"cascade" body to its original position on the natural-stone
bank and place the decorative stones in the water basin.

Plug the transformer power cable in a socket. The natural-
stone water fountain is ready for operation again.
. Maintenance
Dirty water (e.g. from dust) may cause malfunction during op-
eration; this may cause damages to the water pump!
Replace dirty water by fresh distilled water once a week.
To do so ...
 Unplug the transformer.
 Disconnect the water pump power cable from the trans-
former power cable.
IRL
Operating Instructions | 