Safety Instructions - Quadral AURUM ORKAN aktiv Bedienungsanleitung

Technische Daten
Eingangsimpedanz (XLR)
Eingangsempfindlichkeit (XLR)
Eingangsimpedanz (Line)
Eingangsempfindlichkeit (Line)
Maximale Eingangsspannung
(XLR / RCA)
Ausgangleistung (Gesamt)
Harmonische Verzerrungen (Klirr)
Frequenzgang
Eingänge
Unsymmetrisch (Unbalanced)
Symmetrisch (Balanced)
Schutzschaltungen
Auto off (Stand by) nach:
Prinzip Druckkammer/Bassreflex
Bestückung
Maße in mm: Bass/ Mittelton /
Hochton
Netzanschluss
Leistungsaufnahme
Normalbetrieb
Leistungsaufnahme
Vollaussteuerung
Stromaufnahme Stand by
Abmessungen
Höhe
Breite
Tiefe
Gewicht
8
ORKAN aktiv ALTAN aktiv
47 kOhm 47 kOhm
100mV/87dBSPL 100mV/85dBSPL
33 kOhm 33 kOhm
100mV/87dB SPL 100mV/85dB SPL
6V / 6 V 6V / 6 V
320 W 200 W
<0.05% <0.05%
28 Hz - 65.000 Hz 38 Hz - 65.000 Hz
1 x RCA 1 x RCA
1x XLR 1x XLR
Temperatur, Überlast Temperatur, Überlast
15 Minuten ohne Signal 15 Minuten ohne Signal
Bassreflex
2 x 170 / 1 x 170 / 1 x 170 / -- /
Bändchen Bändchen
100V/115V ~60Hz, 230V 100V/115V ~60Hz, 230V
~50Hz ~50Hz
14,3 W 10,6 W
350 W 280 W
<0,2 W <0,2 W
1022 mm 405 mm
222 mm 222 mm
448 mm 345 mm
32640 g 14720 g
First of all we would like to thank you for your decision to purchase our AURUM active
speaker. We manufacture top-quality HiFi equipment in Germany that satisfies the
requirements of music lovers like you and the standard of our equipment is far above
the average. Even if you already know a lot about this type of equipment, we will
introduce some basic rules in the following that will enable you to get the best out
of your new product.

Safety instructions

Please read through these instructions carefully and follow all of the steps listed
here for installing the equipment. You must abide by all of the warnings and safety
instructions that are stipulated on the unit and in this instruction manual. Keep this
manual close to hand so that you can consult it if you have any questions later on.
The lightening symbol inside an
equal-sided triangle is used to
warn you about the presence
of non-insulated components
carrying a dangerous, live
voltage that might cause severe
personal injuries.
• The mains power cable and other connecting cables must be laid so that none
of them are crushed or damaged by furniture, are being trodden on, and / or
that nobody will trip over them.
• Take the power plug out of the socket during lightening storms or if the equipment
will not be used for a long time. Always pull the plug out of the socket and never
remove it by pulling on the cable!
• The amplifier's speaker terminals must only be connected up to the relevant
inputs on the speakers. You must never connect these terminals up to the
electrical mains supply (230V / 115V) as this will destroy the equipment and all
interconnected units immediately. Therefore you must never fit plugs on these
cable connections to ensure that they can never be mixed up with mains plugs.
• Voltages above 30V can be present at the speaker terminals if high volume is
being used. Therefore you should never touch the terminals when the amplifier is
being used.
The exclamation mark inside an
equal-sided triangle indicates
that there is important information
available regarding the use and
maintenance of your equipment.
9