Battery Installation; Battery Storage - BESV TRB1 Benutzerhandbuch

Brake Pad Replacement
A new brake pad must be embedded when they reach the optimum deceleration performance.
Therefore, please speed up the E-bike 25 km/h (15.5 miles per hour) and then brake to stop.
When the required hand force is not reduced, the brake pad replacement is completed.

Battery Installation

When installing the battery, please remove the protective cover of the battery to avoid crashing
the battery terminal.
Open the battery cover with the battery lock. As the figure, to install the battery, hold it with
both hands, put it into the bottom of battery tank slowly, and ensure the correct junction of the
lock cylinder. The incorrect junction of the lock cylinder will cause the unsafe battery. Thus, the
battery cover may open when riding the E-bike. It may raise the unexpected risks. Please follow
the descriptions in the instructions to install the battery and ensure the battery is locked.
As the figure, to remove the battery, please open the cover first. Hold the battery handle with a
hand, and prop the battery and pull it up.

Battery Storage

• Deep discharge of the battery may cause the internal short circuit. Heating the battery to very
high temperature may cause fire.
• Avoid deep discharge during the use and storage of battery.
• When not in use, the battery shall be fully charged once every 3 months at least.
• Do not carry a deep-discharged battery on the E-bike.
If the E-bike or the battery is not used for a long time, please comply with the following
instructions:
• Do not store the battery in the environment with temperatures below -20℃ (-4℉) or above
45℃ (113℉).
16