Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ken des Deckels in Pfeilrichtung mit einem
Schraubendreher lösen und den Deckel abneh-
men. Akku entnehmen und einer geeigneten
Sammelstelle zuführen.
Gewährleistung
Unsere Gewährleistung für Material und Verar-
beitung beträgt 24 Monate. Verschleißteile wie
Batterien und Glühlampen sind von der Gewähr-
leistung ausgenommen. Bei unsachgemäßer
Handhabung besteht keine Gewährleistung.
Device Description
A
Setting collar
-
B
ON – OFF switch
-
Battery-charge indicator
C -
D
Strap fixing
-
E
Fixing clips
-
F
Wall fixing
-
G
Wall plug transformer
-
H – Vehicle on-board charger
Technical specifications
Casing material
Plastics (impact resistant)
Bulb
E10 5.2V/0.85A Halogen
Operating time
Range
Battery
Charging time
100-230 V AC 50/60 Hz;
Charge voltage
Weight
Dimensions in mm
Fitting the wall fixing "F"
Drill two holes in the wall, 110 mm apart verti-
cally. Ensure that the wall fixing is fitted close to a
plug socket. Take care not to damage the mains
supply cable when drilling the holes in the wall.
Now use two screws to fasten the wall fixing to
the wall.
approx. 150 min
approx. 1000 m
NiMH 4.8V/2 Ah
21 h
12/24 V DC
440 g
256x93x93
Charging
Charge the torch for at least 14 hours before
using for the first time. It is charged in the wall
fixing "F" with the aid of the wall plug trans-
former "G". The torch is designed for continuous
charging and is protected against overcharging.
We recommend returning the torch to the wall
fixing when not in use to ensure a fully-charged
torch is available for use at all times. It is not
possible to use the torch while it is being
charged. The charge process is indicated by the
red LED indicator "C".
Use
To use, remove the torch from the wall fixing "F".
To switch it on, push the switch "B" forward. The
operating time of the torch is 2.5 hours (see
technical specification). Use the setting collar "A"
to focus the focal point.
Replacing the bulb
The complete setting collar "A" (with disc and
reflector) can be pulled off to the front by press-
ing in the fixing clips "E" on the sides. The bulb
(see technical specifications) is now freely acces-
sible and can be replaced.
Important information
Only connect the wall plug transformer "G" to an
indoor 120/230 Volt alternating current supply.
Do not expose the torch to wet weather and
extreme temperatures. Always use a damp cloth
to clean the torch.
Disposal information
Do not throw defective NIMH cells or
defective torches in the domestic waste. To
remove the battery, undo the fixing hook of the
cover on the underside of the torch by turning in
the direction of the arrow using a screwdriver
and remove the cover. Remove the battery and
dispose of in asuitable place (battery collection
point).
Warranty for defects
We provide a 24 month warranty for defects for
materials and workmanship. Wear parts such as
bulbs and batteries are not covered by the war-
ranty. No warranty provided for defects resulting
from incorrect use.
Werbung
