Cleaning And Care - Beko TBN7602W Bedienungsanleitung

4 Information
4.1 Tips for blending
• To add ice cubes to mixtures while the blender
is operating, add one cube at a time through the
cap (1). Wait a few seconds before adding the
next ice cube so that the blender can properly
blend the ice.
• To add food while the blender is operating,
remove the cap (1) and drop the ingredients
through the opening. Be sure to cut the food
into about 2-5 cm pieces to fit through the
opening. Replace the cap (1) when you have
finished adding ingredients.
• When blending solid food, such as raw
vegetables, cooked or uncooked meat and fruits
always cut them into no larger than 2-5 cm
pieces before placing them into the jug. Blend
no more than 2 cups of these food at a time.
This will speed the blending process and reduce
wear on the blending blades.
• Always place liquid ingredients in the jug first,
unless a recipe specifically states otherwise.
• To blend beverages, place all ingredients in the
jug at the same time.
• Avoid overblending. Usually, you will need to
blend for a few seconds.
• Overblending may cause food to become mushy.

4.2 Cleaning and care

WARNING: Never use petrol
A
solvents, abrasive cleaners, metal
objects or hard brushes to clean the
appliance.
WARNING: The blades of the
A
cutter unit are very sharp! Handle
the blades with utmost care in order
to avoid injuries.
A
WARNING: Never clean the
appliance with your bare hands.
Table Blender / User Manual
WARNING: Clean the jug blender
A
after each use. Do not let any food
remnants harden on and inside the
jug blender. This will make it more
difficult to clean it later.
WARNING: Do not use boiling
water. The blade assembly bearings
A
have been designed with a lifetime
lubricant; exposure to boiling water
may damage these bearings and
shorten the life of the blender.
1. Turn the appliance off and disconnect it from
wall socket.
2. Allow the appliance to cool down.
3. Remove the jug D from the motor housing (8).
Rinse with water to remove any large food
particles that may have accumulated in the jug.
C
You can use the measuring cup (1) to
remove the blender blade.
4. Turn the glass container over and place it on a
level, non-slip surface. Attach the measuring
cup (1) by placing it over the cutting blade unit
(6). Remove the cutting blade unit (6) by turning
it with the measuring cup in the direction of the
"open lock symbol" (counterclockwise). Glass
container, lid and measuring cup can now be
washed in the dishwasher. Carefully rinse the
cutting blade unit under running water.
5. To place the blade unit (6) back to the glass
container (4), turn the blade unit (6) to the
locking " " direction (clockwise) using the
measuring cup (1).
6. Replace the jug (4) on the motor
housing (8).
7. Place 1 to 1 ½ cups warm water with some
drops of mild cleanser into the jug (4) and
switch to speed "4" for a few seconds. Remove
the jug from the motor housing and rinse with
water. Repeat as necessary.
9 / EN