Replacing The Power Cable - Pattfield PE-EHH 9048 Originalbetriebsanleitung

with any objects such as wire fences or plant supports. This may
damage the cutter bar.
•
Firmly hold the hedge trimmer in both hands, with one hand on
the rear handle and the other hand on the front handle. Your fin-
gers and thumbs should be wrapped around the handles.
•
If a solid object blocks the cutter, immediately switch off the hedge
trimmer, disconnect the power plug and remove the object.
•
Always continue moving away from the power outlet as you work.
Decide on the direction of cut before you start working.
•
Make sure that the extension cable stays out of the work area. Ne-
ver route the cable over the hedge where it could easily by caught
by the cutter blades.
•
Avoid subjecting the hedge trimmer to excessive stress while you
are working.
•
Cutting hedges in the shape of a trapezoid is recommended to
prevent the lower branches from going bare. This corresponds to
natural plant growth and allows your hedge to flourish. If you only
cut back the new seasonal shoots when you are trimming, you will
have a dense hedge which provides good privacy.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged, it must be replaced
by the manufacturer or its after-sales service or similarly trained per-
sonnel to avoid danger.
Anl_PE_EHH_9048_SPK7.indb 203 Anl_PE_EHH_9048_SPK7.indb 203
- 203 -
GB
21.01.16 15:17 21.01.16 15:17