WOLFF VI-D4 Bedienungsanleitung Seite 7

1.3. Constraints:
Concrete Moisture Meter VI-D4 does not detect concrete humidity through electricity conducting materials
like metal coverings/ linings, PE-rubber or any wet surfaces.
Moisture Meter VI-D4 should not be used to measure concrete humidity on surfaces which are topped with a
thick layer of floor covering material like wood.
Meter measurement outcomes show the actual humidity at a time of measurement.
2. How to use guide:
Picture below illustrates meter's front and back panel with most important elements marked:
• To turn on the meter press ON/HOLD button.
• To set the scale press SET button. There are 7 available scales:
1) Concrete
2) Cement Screed
3) CM Cement Screed
4) Anhydrite Screed
5) Anhydrite Screed
6) 15.3 Scale
7) Relative Scale (0-100%)
Name of chosen scale will appear in the scale indicator field.
To see detailed description of each scale go to Available scales section.
• To set the mode of measurement press ON/HOLD button. There are 2 available modes:
1. Normal
2. Max. Hold
The display color will change depending on which mode was chosen.
To see detailed description of each mode go to Modes & functions section.
• To make a measurement press the meter against the tested surface until all spring electrodes are
completely blocked.
!
Caution: Do not press the device too intensely as this may harm the electrodes.
!
Caution: Fingers SHOULD NOT touch the sensor plate and electrodes while measuring.
WOLFF | Eine Marke der Uzin Utz Gruppe | Dieselstr. 19 | D-71665 Vaihingen/Enz | Fon: +49(0)7042-9511-0 | Fax: +49(0)7042-9511-41 |
(0-6%H O)
2
(0-6%H O)
2
(0-4% CM)
(0-3.5% H O)
2
(0-1.9% CM)
(0.3-15.3m)
www.wolff-tools.de
7