Inserting The Batteries - Silvercrest SKD 1000 A3 Bedienungsanleitung

Inserting the Batteries

The battery compartment (13) is located underneath the cassette compartment cover (12).
1. Slide the black release button (5) in the direction indicated by the arrow to release the
cassette compartment cover, and then raise the cover.
2. Insert your fingernail into the recess above the cover of the battery compartment (13) and
open the cover. Remove the cover and put it to one side.
3. Insert the supplied AA batteries into the
unit with the correct polarity (+ and -).
Push the first battery as far as you can
to the left so that it is no longer visible,
and then insert the second battery (see
the diagram to the left of the battery
compartment).
4. Replace the cover on the battery compartment. First position its lower edge on the two lugs
at the bottom left and right of the battery compartment, and then carefully press down the
top edge of the cover with your finger until it clicks into place.
If the volume level drops, or if the device stops operating or the playback
becomes distorted, replace the batteries with new batteries of the same type. The
device does not provide an indication that the batteries are weak.
40
SilverCrest SKD 1000 A3
English