Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Use with two cameras
The Nill tripod head gives you new possibilities in
terms of flexibility and speed: Instead of having to
change lenses and cameras, you can easily mount
two cameras on the Nill head simultaneously.
1. Release the tripod mount ring and turn it 180°,
so that the tap hole faces up. Tighten the tripod
mount ring again and attach the fast mounting
plate (if not already mounted - see page 15)
2. Unscrew the friction control knob and the locking
knob and turn the inner U-bar 180° upward.
3. Now fasten the mounting plate of the 1st camera
in the mounting clamp (your camera is now hanging
from the inner U-bar) and balance the camera. Now
you can mount your second camera to the top of
the inner U-bar using the knurled thumbscrew (see
page 18).
19
Tips
- you can use the long mounting plate attached to
the camera body as a macro adjusting system.
- the head and all parts of it are rust resistant, but
please make sure to avoid any direct contact with
salt water.
- neither the friction control knob nor the locking
knob need to be oiled. If pan function becomes
compromised through contamination with dust or
sand you can contact us to receive a special repair
guide in order to restore the head's original func-
tion.
- feel free to contact us with any critiques or com-
ments at kontakt@dietmar-nill.de
technical specifications
material
anodized aluminium
weight (classic)
2.7 pounds / 1220 g
weight (EX)
weight mounting
plates
load capacity
(1 telephoto lens)
approx. 33 pounds/15 kg
load capacity
(use for upright for-
mat pictures)
height/depth/width
depth of the gimbal
3.15" / 8 cm (classic)
mounting
warranty
3 pounds / 1360 g
1.6/2.9/4.2 oz
46/83/120 g
approx. 5.5 pounds
/2.5 kg
7/3.7/9.4 inches
176/95/238 mm
5.5" / 14 cm (EX)
5 years
20
Werbung
