Notes On Safety And Danger; Return - Weflow ETK-EAM Betriebsanleitung

EN
24 | Operation
Operation
This product may only be assembled, fitted or exchanged by qualified
and instructed specialists such as plant engineers for sanitation, heating
or airconditioning technology.
Intended use
Water meters are used to register the consumption of drinking water.
Depending on the type, they are suitable for cold or hot water
Any utilisation that differs from these instructions has to be approved by
WEHRLE GmbH PREVIOUSLY IN WRITING. The water meters are
exclusively intended for the above mentioned purpose. Any other
utilisation going beyond this or any conversion or modification of the water
meter will be considered as improper use and is not allowed The relevant
and valid national regulations concerning the duration of use are to be
observed (the calibration regulations in particular).
The nominal operating conditions according to type approval certificate
and the information on the meters are to be observed. The original
operating instructions must be stored near the measuring device.

Notes on Safety and Danger

Water meters must be well vented before putting them into operation. Any
remaining air will lead to incorrect measurement results To ensure correct
function, the water meter must therefore always be full of water.
Pressure shocks in the pipe could damage the meter! Improper fitting,
pressure tests, modifications or incorrect operation can lead to personal
injury or damage to property. The following instructions are to be read
before mounting. If the seal is damaged or removed, the use of the water
meter for legal measurements is no longer permitted.The water meter must
be checked for transport damage before installation. Do not drop the
device nor hold it by the protective cover or cable.

Return

Return the water meter to the supplier (distributor) in a suitable packaging
carriage paid. Insufficiently stamped returns will not be accepted!