Maintenance; Replacing The Mains Cable - Rothenberg Industrial HS-060B-30 Gebrauchsanweisung

ADDITIONAL INFORMATION ON SOLDERING
Solder and flux
Solder for the DIY market is almost exclusively produced in the form of wire.
There are two types of solder wire on the market:
1. Simple, unfilled solder wire.
2. Solder wire with flux core
Electronic solder
Radio solder
Soft solder
Solder stone
Soldering grease
Liquid flux

MAINTENANCE

REPLACING THE MAINS CABLE

The soldering iron is fi tted with a special mains cable, which may not be damaged. When
working, take care not to touch the mains cable with the hot soldering iron. To prevent
the risk of injury, damaged mains cables may only be replaced by the manufacturer, by
customer service or by a similarly qualifi ed person.
MAINTENANCE
The tip (6) is a wear part and must be replaced from time to time.
Loosen the screw (8) on the metal shaft of the soldering iron and remove the worn tip.
Replace with a new tip. Re-tighten the tip fi xing screw (8).
1500000041_Anleitung_DE,GB,FR_Ausgabe 80%.indb 12 1500000041_Anleitung_DE,GB,FR_Ausgabe 80%.indb 12
Melting point 185° C approx
For use with electronics
For model making or fine soldering
Melting point 235° C approx.
For general purpose soldering
For cleaning the tip
Flux paste
Flux for inaccessible workpieces
12
14.10.15 13:26 14.10.15 13:26