Blaupunkt TBP601 Bedienungsanleitung Seite 7

TBP601
1. Body with the motor
2. Rotor
3a. Cocktail bottle
3b. Blades for the blender
4. Lid with a mouthpiece
5. ON button
BEFORE FIRST USE
1.
Remove all papers, cartons, foil which secure the blender and blender's parts
2.
Clean the blender following the advice in Cleaning and Maintenance chapter.
FOOD PREPARATION
Remove stones (plums, peaches, cherries etc).
Remove tough skins (melons, pineapples, cucumbers, potatoes etc).
Soft-skinned and other foods just need washing
Cut the food into small pieces (2-3 cm).
USING THE BLENDER
Put the ingredients into the cup. Pour some water. It is recommended not to fill more than ¾ of cup's
capacity. Assembly blades (3b) on a bottle (3a). Put a bottle with blades mounted on the base of the
device (1) fitting into the rotor (2), then turn to lock.
Note: the blender jar need to be hold during operation.
Plug the blender to the mains.
Turn on the blender pressing the button (5).
When the ingredients will become the right consistency, turn off the device. Do not operate the
blender for more than 3 minutes. Wait 30 minutes before the next run.
After preparing the cocktail unscrew the set of blades (3b) of the bottle (3a). Screw the lid with a spout
(4).
After operation, pull out the plug from the electric socket.
USING THE CHOPPER
Mount the blades (6a) in the chopper's bowl (6b). Put the ingredients to be processed into the bowl
(6b). Close the bowl (6b) with the lid (6c). Mount the body with the motor (1) on the chopper (6). Plug
the power cord into an electric socket. Start the chopping process by pushing the ON button (5).
Unplug the appliance once the ingredients have been chopped. Dismount the body with the motor
from the chopper. Remove the lid. Be extra careful when removing the blades.
USING THE DRY GRINDER
The grinder is suitable only for grinding dry products, such as coffee beans or nuts.
Put the products to be processed into the bowl of the grinder (7a). Screw the base with blades of the
grinder (7b) onto the bowl (7a).
Mount the grinder (7) on the body (1). Plug the power cord into an electric socket. Start the appliance
by pushing the ON button (5).
Unplug the appliance once the ingredients have been milled. Dismount the grinder (7) from the body
(1). Unscrew the blades from the bowl.
CLEANING AND MAINTENANCE
Make sure the blender has been disconnected from the power source.
Clean the body (1) with a slightly damp cloth and then wipe it dry. Do not submerge the body in water
or other liquids.
6a. Choppper blades
6b. Chopper bowl
6c. Chopper lid
7a. Gridner bowl
7b. Blades for the grinder
5