Change The Sound Level Of The Beep Tone; Restore Factory Settings; Replacing The Battery - Miscea Remote Control Bedienungsanleitung

3. Use - Cont.
3.12

Change the sound level of the beep tone

The sound level of the beep tone can be changed.
Press the «BEEP» button. Use the «+» and «-» buttons to switch between the 9 different
sound level settings. To save settings, press the «SAVE» button. All colored LED lights
illuminate to indicate new setting has been saved. If «SAVE» button is not pressed within
10 seconds of last selection, previously saved setting will be stored.
There are 9 settings available. Each setting is indicated with a different beep tone. For
miscea models with a display screen, this will also be indicated visually on screen.
Please see Fig. C - E for technical data.
3.13

Restore factory settings

The «DEFAULT» button can be used to restore the miscea system to factory settings. To
restore factory settings, press «DEFAULT». All colored LED lights will start blinking.
Press «SAVE» to finalize factory restore.
If the «SAVE» button is not pressed within 10 seconds of last selection, previously saved
setting will be stored.
Please see Fig. C - E for technical data.
3.14

Replacing the battery

To replace the battery when it is out of power, see Fig. B01-B04.
14
BEEP
DEFAULT