Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
The manufacturer does not accept any responsibility for injuries or damage resulting from improper use of the
product.
2.
Maintenance of the product is limited to the surfaces. When doing this, no moisture must come into contact with
any areas of the terminal connections or mains voltage control parts.
3.
The product has a protection class rating of "IP20", and is solely intended for use in interior areas of private house-
holds.
4.
The light source of this lamp is not replaceable. If the light source has reached the end of its operational life, the
entire lamp must be replaced.
5.
Place the lamp on horizontal surfaces only.
6.
LED colour deviation when using different lots may occur. The light colour and luminous strength of the LEDs can
also change as a result of battery life span level.
7.
Batteries or rechargeable batteries are not permitted in domestic waste. They must be decontaminated according
to the regulations of the responsible authorities as hazardous waste. Use the available collection points.
STARTUP PROCEDURE
This is what you should do:
1.
Place the product on an easily accessible, even, dry, heat-resistant and sufficiently stable area.
2.
Always pay attention and take the utmost care! Work with the highest level of reason.
3.
Do not cover the product with other objects. Excessive heat generation can cause the risk of fire.
4.
Do not stare into the LED from short distance during operation.
5.
Do not look at LEDs with an optical instrument (e. g. magnifier).
6.
The LEDs are not replaceable. Should LEDs become defective please dispose of the whole product.
Check the LED light box and the scope of delivery:
Risk of damage!
If you open the package carelessly with a sharp knife or other sharp objects, the product can be easily damaged. Be very
careful when opening the package.
1.
Remove the product from the packaging.
2.
Check whether the delivery contents are complete.
3.
Check whether the product is damaged.
The cards with letters, numbers, illustrations can be inserted individually ③ .
4.
You can turn the LED light box on and off via the on/off switch ④.
5.
Insertion of batteries:
Open the battery box by removing the screw and the cover ①.
1.
Insert the batteries that come with the product into the battery compartments and pay attention to polarity (+ / -) ②.
2.
Close the battery box by inserting the cover and the screw ①.
3.
4.
The product is now ready to use.
Wall installation:
Wall mounting is possible. Attach the product to a hanger using the holes on the back side of the product ⑤.
BATTERY REPLACEMENT
Open the battery box by removing the screw and the cover ①.
1.
2.
Remove the batteries from the battery compartments.
Insert the new batteries into the battery compartments. Pay attention to polarity (+ / -) ②. Only use fresh batteries of
3.
the same type.
Close the battery box by inserting the cover and the screw ①.
4.
TECHNICAL DATA
Product number:
R1784
Operating voltage: 6V (4 x 1.5V AA battery)
Bulb:
LEDs, not replaceable
Protection class:
III
Protection rating:
IP20
Werbung
Inhaltsverzeichnis
