Teesa SMOOTH TOUCH TSA5010 Bedienungsanleitung Seite 17

Owner's manual
Note:
• To clean the selected surface you can use the sprayer with the
attached wiper head. First, make sure that all of the parts were
assembled correctly (see section Assembly – Accessories). Make sure
the water tank is filled with the selected window cleaning agent or
water. Then set the tip of the sprayer to the selected position: STREAM
(foam) or SPRAY (water mist). Spray the surface to be cleaned. Finally,
use the wiper head or the cloth to clean the surface.
• To clean the surface you can use TEESA cleaning supply.
2. Turn on the window vacuum cleaner by pressing and holding Power
button. Blue LED is on.
3. Place the rubber lip of the device on the surface to be cleaned and
using light pressure pull it from top to bottom across the surface.
Repeat this step until the surface is completely cleaned.
Note: Avoid sucking in dust and dirt.
4. If the maximum fill level (marked "MAX") of the water tank has been
reached, the tank must be emptied.
Note: It is recommended to empty the tank before the maximum water
level has been reached. Otherwise, small amounts of water may get
into the ventilation system and damage the device.
5. To empty the water tank, firstly turn off the device by pressing Power
button.
6. Then pull the water tank plug and pour dirty water into a container or
sink.
7. Close the water tank opening with the plug afterwards.
8. When working with the device is finished, press Power button to turn it
off. LED indicator goes off.
Note: After each use remember to clean the device (see section
"Cleaning and maintenance" and fully charge it (see section "Before
first use").
HAND VACUUM CLEANER
1. Turn on the device by pressing and holding power button.
2. Start the vacuum process.
3. When working with the device is finished, press Power button to turn it
off. LED indicator goes off.
17
EN