Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Some time after the programme
has started, a continuous buzzer
is emitted.
The appliance is not being filled with
water. When the appliance door is
opened, "Check water supply!" is
indicated.
Tap not turned on.
Turn on the tap fully and press
the "Continue" button
on the appliance. Then close the
appliance door to continue the
programme.
The filter on the water supply hose
is blocked.
Switch off the appliance and pull
out the mains plug. Turn off the
tap. Then clean the filter which is
situated at the connection of the
Aqua Stop or supply hose. Finally,
restore the power, turn on the tap,
switch on the appliance and close
the door to continue the
programme.
Warning
Remember:
The appliance may be repaired
by a technician only. Improper
repairs may cause
considerable damage and/or
injure the user.
... with the appliance itself
Lower spray arm rotates with
difficulty
Spray arm is blocked by small
items or food remains.
Lid in detergent compartment
cannot be closed
Detergent compartment has been
overfilled.
Mechanism is clogged with
remnants of detergent.
Indicator lamps do not extinguish
after washing has finished.
Remnants of detergent stuck inside
dispenser
Compartment was damp when it
was filled up with detergent.
Compartment must be dry before
detergent is added.
At the end of the programme there
is still water in the appliance.
The waste water hose is blocked
or kinked.
The waste water pump is blocked.
The filters are blocked.
The programme has not yet
ended. Wait until the programme
ends or terminate the programme.
... during washing
Unusual amount of foam is created
Normal washing up liquid has
been poured into the rinse-aid
container.
Remove any spilled rinse aid with
a cloth as it could otherwise lead
to excessive foaming during the
next washing cycle.
Appliance stops suddenly while
washing is taking place
Cut in electricity supply to
appliance.
Water supply has been
interrupted.
en
51
Werbung
Inhaltsverzeichnis
