Care And Maintenance - Bosch SGS2029 Gebrauchsanweisung

Terminating the programme
Switch off the main switch
To pump residual water out of the
appliance interior, rotate the programme
selector in a clockwise direction to
1
the drying symbol
main switch
4
Wait briefly until the pump noise is no
longer audible and the programme
selector has reached its initial position
(12 o'clock position). Now switch off the
appliance.
Changing the programme
Switch off the main switch
Set the programme selector
the new programme (rotate in
a clockwise direction only!).
Switch on the main switch
Check whether the detergent dispenser is
still closed. Otherwise, refill with detergent.
Note
If the power supply is
disconnected while the appliance
is operating, e.g. by switching off
the appliance or due to a power
failure, all settings remain stored.
Operation continues automatically
as soon as the power supply is
restored.
.
4
and switch on the
again.
.
4
to
1
again.
4

Care and maintenance

Regular inspection and maintenance of
your appliance helps to prevent problems
from occurring. This saves time and
aggravation. You should therefore
carefully inspect the inside of your
dishwasher from time to time.
Overall condition of appliance
Check that no grease or scale has
accumulated on the inside of the
dishwasher.
If you discover any deposits:
Clean the interior of the dishwasher
thoroughly with a detergent solution.
Dishwasher salt
Check the LOW SALT indicator
up with salt, if required.
Rinse-aid
Check the level of liquid in the rinse-aid
container . Top up with rinse-aid, if
42
required.
Filters
The filters keep large foreign objects
40
in the rinsing water away from the pump.
These foreign objects may occasionally
block the filters.
After each washing cycle check the
filters for residue.
Unscrew the filter cylinder and remove
the filters. The filters are permanently
attached to each other and cannot be
dismantled.
Remove large foreign objects. Clean
the filters under running water.
en
. Top
39
35