Zipper 912003923836 4 Bedienungsanleitung Und Sicherheitshinweise Seite 20

• Danger of injury for the eyes through flying parts, even with protecting glasses.
• Danger through breathing of poisonous dust (treated wood)
These risks can be minimized, if all the safety regulations are applied, the machine is main-
tained regularly and the machine is operated from trained expert staff.
2.4 Assembly
• Fig. A
o Put the feet 2 as shown in the picture on the main part 1. For this you have to use for
every foot 2 six-head screws M6x16, nuts and flat washers. Don't tighten the screws too
firmly!
• Fig. B
o Then mount the switch 6 on the main part 1 with 2 nuts M4 and flat washers.
• Fig. C
o Fix the last foot 5, the extension table 8 and the hose clip 7 with 4 nuts M6 and 4 flat
washers on the main part 1. You can see this position in Fig. U.
• Fig. D
o Use 12 six-head screws M6x16 and the related nuts and flat washers to connect the feet
2, 3, 4, 5 with the transverse strip 9, 10.
• Fig. E
o Mount the column fort he extension table 11 on the extension table and the transverse
strip 9 by using 4 six-head screws M6x16 and the related nuts and flash washers.
• Fig. F
o Assemble the guideline for the fence 15 on the front side of the machine 1. Use 2 screws
M6x30.
• Fig. G
o The second guideline has to be mounted on the left side of the machine.
So the fence can be changed between these two guidelines later.
• Fig. H
o Fix the dust collector plug 14 with 4 six-head screws M4x10 on the holder 13.
• Fig. I
o Using 4 six-head screws M6x16, you have to fix the two wheels on the feet 4, 5.
• Fig. J
o Drag the screws at the positions A and B behind.
• Fig. K
o Drag the screws at the places A to G behind. Let the screws at position H loose.
• Fig. L
o Now turn the table round, so that it stands on its feet. Then adjust part 17 on part 16 so
that the wheel touches the floor. Now drag the screws at this place behind.
• Fig. M
o Loose the screw A and mount the riving knife 18. You have to adjust it so that the dis-
tance, shown in the picture, is reached. Now fasten the screw again.
• Fig. N
o Move the saw blade to the lowest position. Insert part 19 and fix it with 4 cross counter-
sunk screws M6x16.
• Fig. O
o Use a screw M6x25 and the related nut to mount the protective cap on the riving knife.
20