Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.0 Setting to work
Before setting the grinding machine to work you have to control the grinding wheels. In a matter of transportation
the grinding bases and guards are not assembled to the machine. Connect them with the delivered screws as
shown in picture 1. Adjust the grinding bases in accordance with the grinding wheels. Too wide spacing between
grinding base and wheel may cause serious accidents. The spacing may therefore amount to 3 mm maximum.
When the machine is connected to the local mains care must be taken that the voltage correspondent to the rating
shown on the performance plate. The machine may now be taken in operation by switching on the switch (5).
6.0 Proper use
The bench – and disk sanding machine you have purchased is reliable in operation and built in accordance with the
latest state of the art. Hazards for life and limb can only arise for the user of this machine if he uses it improperly.
This machine is only suitable for conventional grinding of sparked metal using usual grinding tools.
Using the machine for any other purpose counts as using it in an improper manner. The manufacturer cannot held
liable for any damage resulting for the use of the machine in an improper manner. The user carries the sole
responsibility for such use.
The machine may only be used, maintained and serviced by persons who are familiar with the machine and who
have been instructed in the relevant risks. The existing operating instructions should be noticed and always be
available. Any changes carried out to the machine other than by the manufacturer remove the liability of the
manufacturer for any damage that occurs as a result thereof.
7.0 Change of grinding wheel
1) De-mounting of the protection hood.
2) Loosen nut.
3) De-mounting of grinding wheel and flange.
4) The inner flange remains on drive shaft.
5) Mounting of new wheel.
6) Check of true run (axial and radial) with tool such as chisel.
7) Correction of run out with plastic hammer and tightening of nut.
8) Assembly of hood, spark protection and tool support.
The distance between tool rest and grinding wheel should not exceed 3 mm.
9) Machine should run for about 5 min with no load. No person should be close the site.
Attention! Do not use damaged grinding wheels.
Simply guide of wheel check: Hang grinding wheel with the help of a thread.
With a piece of hardwood knock on wheel. A good wheel gives a clear sound.
Do not drill holes into a grinding wheel.
It is within tolerance that the grinding wheel turns with a radial and axial run out of 0,4 – 0,6 mm
at the outer perimeter.
By change of grinding wheel we recommend: Original "FLOTT" accessories.
8.0 Optional equipment
Designation
Grinding wheel *
Normal Corundum coarse
Grinding wheel *
Normal Corundum fine
Wall bracket
Machine stand with water
container
Truing stone
Extraction Unit MA 400
Extraction Unit MA 600
* consumable parts
317770 D/GB
GB
TS 150 SW
TS 175 SW
TS 150 SD P TS 175 SD P TS 200 SD P TS 250 SD P TS 300 SD P
317522
317526
317523
317527
315035
315035
350435
350435
350101
350101
---
---
---
---
Order No.
317522
317526
317523
317527
315035
315035
350435
350435
350101
350101
330295
330295
---
---
317532
317542
317533
317543
315035
---
350435
350436
350101
350101
330295
---
---
330080
317622
317624
---
350436
350101
---
330080
10
Werbung
