Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Pusher
A
Filling hopper
B
Squeezing screw
C
Drum
D
E
On/off switch (3 levels)
Disassembly before first use
The
is supplied with the squeezing screw
inserted in the drum
and the filling hopper
D
assemble and clean these parts before first use.
•
Hold the drum
D
securely and turn the filling hopper
anti-clockwise until the
marking on the drum (detail
•
Remove the filling hopper
•
Lift the squeezing screw
To do this, reach your index finger under the first
TIP:
ridge of the squeezing screw.
Assembly/disassembly
•
Make sure:
- that the appliance's plug is disconnected from the
mains and that the on/off switch
tre position).
- that the yellow silicone seal on the underside of the
drum
D
is fitted as far as the marking line in the slot
on the pulp outlet
I
.
1
Position the drum
D
flush
IMPORTANT:
Position the juice outlet
recess in the motor unit
square recess.
Insert the squeezing screw
2
the squeezing screw down by turning it slightly.
Position the filling hopper
3
marking is above the
Open
(detail
X
).
4
Turn the filling hopper
marking is above the
and engages with an audible click
•
It can be disassembled using the same steps in reverse
order.
Subject to technical changes without notice; no responsibility is accepted for the accuracy of this information.
Motor unit
F
Rating plate
G
Juice outlet
H
Pulp outlet
I
fitted. Dis-
B
marking is above the
Open
).
X
in an upward direction.
B
up out of the drum
.
C
D
is set to
E
OFF
on the motor unit
F
.
H
over the round
F
and the pulp outlet
I
over the
into the drum
and press
C
D
on the drum
so that the
B
D
marking on the drum
B
clockwise until the
Close
marking on the drum (detail
.
First use
•
Make sure that the appliance's plug is disconnected
from the mains and that the on/off switch
OFF
(centre position).
•
Before using the appliance for the first time, thoroughly
clean all parts of the appliance (see section
•
Always ensure that the appliance is completely assem-
C
bled before operating it. Always fit
ing hopper
before operating the appliance!
B
•
Place the appliance on a non-slip, even and clean sur-
face.
B
•
Place one container under the juice outlet
other under the pulp outlet
•
Plug in the mains plug.
Switching on the appliance
CAUTION Rotating parts can cause injury!
Never put your hand into the appliance when the motor
is running.
NOTE
Risk of damage to the appliance!
•
Do not insert any objects into the juice outlet
outlet
while operating the appliance.
I
(cen-
•
Always fit
and engage
ating the appliance!
•
Never operate the appliance when the drum is empty.
•
Do not disassemble the appliance during operation.
•
Do not move the appliance during operation.
NOTE
Damage due to being operated for too
long!
The appliance is only suitable for short-interval operation
of max. 20 minutes at a time. After that the appliance must
cool down.
NOTE
Motor can overheat!
If the appliance does not start when you switch it on (
is set to
ON
), press
not help, switch the appliance off immediately (see section
Troubleshooting)
The appliance has a 3-level on/off switch.
•
ON
ON; appliance is switched on, motor is running.
•
OFF; appliance is switched off.
OFF
•
REVERSE; button; appliance runs backwards. This
REV
releases any food to be juiced that is jammed in the
squeezing screw (see section
Y
)
and engage
I
.
the filling hopper
B
REV
for 2 - 3 seconds. If this does
.
Troubleshooting
E
is set to
).
Cleaning
the fill-
H
and the
H
or pulp
before oper-
E
).
7
Werbung
Inhaltsverzeichnis
Fehlerbehebung
