Set Schedule; Disable Schedule; Run The Schedule; Run Schedule From Slideshow - HP df840p3 Bedienungsanleitung

Set Schedule
You can schedule the DPF to automatically go into a "stand-by" mode and resume operation according to your weekly
schedule. For example, if you have your DPF on your desk at work, you may want to display the calendar/clock or
play a slideshow from 8:30am to 5:30pm every weekday, and then set the DPF to remain in stand-by mode
throughout the weekend. The following Monday morning, the DPF would resume operation at 8:30am.
CALENDAR/CLOCK
1. On the
2. Select
Set Schedule
3. Use
4. To set the
settings.
5. Use
6. When correct times are set, select
Disable Schedule
After the schedule has been enabled (per above instructions), you can disable the schedule whenever desired.
CALENDAR/CLOCK
1. On the
2. Select
Set Schedule
The time fields will display
3. Select
Done
Run the Schedule
After the schedule times have been set (per above instructions), you will use the
you want the schedule to take effect.
There are two methods for running the schedule, either from a slideshow or from the
CAUTION: After you select the
Run Schedule from Slideshow
1. Start a slideshow, and then press
small timer clock will appear indicating the schedule is active. To run the schedule when the
button is no longer displayed, restart your slideshow and then press
appears again.
2. The DPF will go into stand-by mode according to the schedule, and when it resumes operation, the
slideshow will again begin
to play.
Run Schedule from CALENDAR/CLOCK Screen
1. On the
2. Select
operate according to the set schedule.
3. The DPF will go into stand-by mode according to the schedule, and when it resumes operation, the
Calendar/Clock
14
screen, press
.
to move between the fields and
Weekends On/Off
, select the
to move between the fields and
Done
screen, press
, and then select the
.
OFF
.
Run Schedule
pressing remote or control button, powering off) and the schedule will not take effect until you select
this function again to re-activate.
CALENDAR/CLOCK
. A small timer clock will appear indicating the schedule is active, and then the DPF will
Run Schedule
screen will again be displayed.
.
to change the field values in
Enable Weekends Schedule
to change the field values in
to return to the previous screen.
.
Enable Weekdays Schedule
function, any user intervention will cancel the activation (i.e.,
when the
Run Schedule
screen, press .
Weekdays On/Off
button, and then use
Weekends On/Off
or
Enable Weekends Schedule
function whenever
Run Schedule
CALENDAR/CLOCK
button appears (approx 10 seconds). A
when the
Run Schedule
.
to access the
.
button.
screen.
Run Schedule
button