Connecting The Interface Via A Keyboard Port - Gewa Access Gebrauchsanleitung

2. Connect the provided USB cable between the interface and the computer's
USB port. No other cables shall be connected.
3. Start the computer. A dialog box may appear prompting you to insert the
operating system's installation CD.
4. Select the same ID as for the transmitter unit. See Installing the ID Selector
for more information.
5. Place the interface at the computer, making sure that the IR lens at the front
of the unit is unobstructed.
Interface from the rear
8
4
0
Keyboard
port
ID selector

Connecting the Interface via a Keyboard Port

For a computer without USB ports, the interface is connected to the computer's
keyboard port, which means that the computer's standard keyboard cannot be
connected as usual. To solve this problem, a branching adapter can be used. The
branching adapter is not provided and must be purchased separately.
To connect the interface:
1. Make sure that the computer is turned off.
2. Connect the provided keyboard cable between the interface's keyboard port
and the computer's keyboard port. If the cable connector doesn't fit the
computer's keyboard port, an adapter must be connected between the
connector and the computer. This adapter is not provided.
If a conventional keyboard will be used at the same time, a branching adapter
must be used as shown in the figure.
3. Start the computer.
4. Set the same ID as for the transmitter unit. See Installing the ID Selector for
more information.
5. Place the interface at the computer, making sure that the IR lens at the front
of the unit is unobstructed.
C
USB
port
To computer's
USB port
13