Aqua Medic LEDspot 100 Bedienungsanleitung Seite 5

1. Technical Data
Line voltage: 230 Volt/50 Hz (if not stated otherwise on the ID-label).
Luminaires: 100 W resp. 200 W LED chips (12,000 Kelvin), 90° bundled.
The electronic ballast is placed in a splash-proofed body on the light. The cooling element is made
of saltwater-resistant anodized aluminium. The cooling is done passively. Diametre: 32 cm. Height:
100 W = 38 cm, 200 W = 48 cm. The spotlight can be hung up with a chain or screwed on with the
holder.
2. Unpacking
On unpacking, please check the light immediately for any damages. In case of any complaints,
please contact your dealer directly.
Included in shipment:
LEDspot with holder and central loop for hanging up with chain
•
3. Safety advices
The light cannot be used as aquarium cover. It has to be mounted only above the aquarium. If
•
it is mounted above the aquarium, the minimum distance between lighting and aquarium must
be at least 30 cm.
The housing may become hot during operation. Be cautious when touching it! For cleaning,
•
disconnect the light from the mains and let it cool down. Afterwards, take the light down.
When cleaning, take care that no humidity enters the interior of the light!
•
Pay attention to a sufficient thermal exchange. Keep the ventilation slits always free! Do
•
not mount the system in enclosures or behind panels. Missing aeration may result in
overheating and damage the electrical components.
Do not try to repair the light (LEDs, electronic parts). Please send it in for checking, preferably
•
with a list of defects. Also, broken LED chips can be exchanged only by the manufacturer.
When working on the light, always pull all power plugs.
•
4. Installation
The light can be hung up on the central loop with a chain on the ceiling or can be screwed on with
the holder.
4.1. Assembling/changing the LED chips
Broken LED chips can be exchanged only by the manufacturer.
Electric connection:
LEDspot
The can be connected to a timeswitch or a PWM timer if automatic operation is desired
or can be controlled by 0 – 10 V. A power plug is not included. The cable for the power supply
and the control cable come out of the light from above and must not be mixed up.
When working on the light, always pull all power plugs!
5