Indicators And Operating Controls - YUNTO Q 700 Benutzerhandbuch

3. Indicators and Operating Controls

The front panel LEDs and audio beeps indicate the UPS status.
Switch and LEDs
On/Off
Status-LED
(green)
Fault-LED
(red)
Beeps
Beep continuously
for 2 sec
1 beep every 4 sec
1 beep every sec
1 beep every 2 sec
3 beeps every 2
sec
2 beeps every 2
sec
1 beeps every half
sec
Continuous
YQ_manual_ger-eng-it_ 2009-09-29.doc
Symbol
Turn the UPS system on and off.
1. Steady: Input power is acceptable,
2. Blinking: Input power is out of
3. Off: No input power or
1. Blinking: The UPS is overloaded or
2. Steady: UPS fault.
Starting up the UPS.
Power failure: UPS is in battery mode.
Battery low: UPS is in battery mode, batteries are
nearly exhausted, UPS will be shut down.
Battery weak: UPS in normal mode (online), battery is
not fully charged, backup time during power failure
shorter than nominal value.
Battery replacement: battery needs to be replaced.
Charger fault: UPS can not recharge the battery. See
chapter Troubleshooting for more information.
Overload. See chapter Troubleshooting for more
information.
Fault: please contact your dealer.
21
Function
the UPS is in normal mode (online).
tolerance, the UPS is in battery mode.
the battery is exhausted or
the UPS is switched off.
has failed at battery test.
Function
9/29/2009, S. Spitzley