Weidmuller IE-SW6/2SCS-M Handbuch Seite 14

1 1 I I n n s s t t r r u u c c t t i i o o n n s s
1 1 . . 1 1 S S a a f f t t y y i i n n s s t t r r u u c c t t i i o o n n s s
1 1 . . 2 2 C C E E M M a a r r k k i i n n g g
This product confirms to the required regulations of the European Union (EU). This
product is marked with the CE marking.
1 1 . . 3 3 L L a a s s e e r r c c l l a a s s s s 1 1
Exceptions: IE-SW8-M, IE-SW16-M, IE-SW24-M
1 1 . . 4 4 C C l l a a s s s s I I D D i i v v i i s s i i o o n n 2 2
W W a a r r n n i i n n g g
- Using this product beyond the specifications or disregard of using instructions
and warnings can cause grave malfunctions so that personal injury and material
damages occur. Use the product only in accordance with the requirements.
- In the case of malfunction or failure of the IE-SWx-M cannot be predicted the be-
haviour by other connected devices of an arrangement. It can occur personal da-
mages and material damages. Make only settings, if you are informed exactly
about all effects in the whole arrangement.
L L a a s s e e r r c c l l a a s s s s 1 1 I I E E C C 6 6 0 0 8 8 2 2 5 5 - - 1 1 ( ( E E N N 6 6 0 0 8 8 2 2 5 5 - - 1 1 ) )
Embedded class 1 laser - exposure hazard exist only if protective housing is remo-
ved. All not mentioned applications can cause the emission of laser.
W W a a r r n n i i n n g g
- Substitution of components may impair suitability for Class I Division 2. It occur
Explosion Hazard. You make sure, the modules are open devices intended for in-
stallation/dismounting in an ultimate enclosure suitable for the intended application.
- Do not disconnect equipment unless power has been switched off or the area is
known to be Non-hazardous. It occur Explosion Hazard. Use only for the applica-
tion in Class I Div 2 certain connections with this device. Follow the allowed envi-
ronment temperature range by the installation.
This equipment is suitable for use in Class I Division 2, Groups A, B, C, and D or
Non-Hazardous locations only.
14 14 14