Operating Procedure - Siemens LC 99 Serie Gebrauchsanleitung Und Montageanleitung

Operating procedure

The most effective method of removing
vapours produced during cooking is to:
Switch the ventilator ON
as soon as you begin cooking.
Switch the ventilator OFF
a few minutes after you have finished
cooking.
Display for
fan setting
Light Reduce fan speed
Fan – OFF –
Acoustic signal:
When a button is pressed, this is verified
by an acoustic signal.
Switching off the acoustic signal:
Simultaneously press buttons
Ü
and – until a signal is emitted after
approx. 3 seconds.
Switching on the acoustic signal:
Repeat the process.
Switching the fan ON
Ü
Press the + button.
Setting the required fan speed:
Ü
Press the + button.
The fan speed is increased by one step.
Ü
Press the – button.
The fan speed is reduced by one step.
Switching the fan OFF:
Intensive setting:
Maximum power is obtained at the
intensive setting. It is only required for short
intervals.
Lighting:
Fan ON and
increase speed
Switching on the light automatically, e.g.
via a timer:
–
0
Switching on:
Simultaneously press the
buttons.
Switching off:
Repeat the process with the light switched
on.
Ü
Keep pressing the
fan switches off.
The displayed { goes out shortly
afterwards.
Ü
Keep pressing the
appears in the display.
If the intensive setting is not cancelled by
hand, the fan will automatically switch
back to step } after 10 minutes.
Briefly press the +/
0 0
switch the light on and off.
The light can be switched on at any
time, even though the fan is switched off.
Adjusting the brightness:
Hold down the + or
0
the desired brightness is obtained.
Fan and light must be switched off.
After approx. 3 seconds the light
switches on to acknowledge the setting.
After approx. 3 seconds the light
switches off to acknowledge the setting.
– button until the
ç
+ button until a
– button to
– button until
0
– and +
0 0
19