Werbung
Verfügbare Sprachen
Verfügbare Sprachen
19742 Tablet PC stand holder
INSTALLATION (A-I)
Continuation
F ATTACHING THE CRADLE
F
13 Place the cradle on the four hooks of the
F 13
swivel joint
F
14 Slide the cradle to the stop position (you will
F 14
hear a click)
G CLIP THE TABLET PC IN THE CRADLE
G
15 "Move the "small latch" upwards (click!)
G 15
- this allows the arm to be moved upwards
G 15
against a spring tension
G
16.a Hold the cradle firmly with one hand...
G
16.b ...align the tablet PC centrally in the
G 16.b
clamping jaw and slide upwards until...
G
16.c ...the tablet PC can also be clipped into
G 16.c
the lower side of clamping jaw
G
17 The spring tension of the arm will push the
G 17
tablet PC onto the four moss rubber
G 17
protectors of the clamping jaw
G
18 NOTE:
G 18
The tablet PC should sit neatly with the
G 18
guard arm. The position of the guard arm
G 18
may need to be corrected depending on the
G 18
size of the tablet PC. See I 23 ,24 & 26, 27.
G
19 Now slide the "small latch" down (click!) -
G 19
the upper jaws are now securely fixed
H REMOVING THE TABLET PC FROM THE CRADLE
H
20 Slide the "small latch" up again - the pull-out
H 20
section is now released
H
21 Hold the tablet PC and use it to push out
H 21
the top side of the cradle
H
22 Unclip the tablet PC in a downwards motion
H 22
and remove
I DISMANTLING (Fig.re.)
I
(e.g. to re-position the guard arm 3)
I
23 Release the lock between the tablet cradle
I 23
and the swivel joint as follows:
I
23.a Press the lever down and hold down
I
23.b Slide the tablet cradle upwards to stop
I 25.b
approx. 6 mm
I
23.c Lift the tablet cradle
I
24 Remove the guard arm
I
25 If required, the swivel joint can be
I 25
unscrewed from the stand
I DISMANTLING
Werbung
