Werbung
Verfügbare Sprachen
Verfügbare Sprachen
19742 Tablet PC stand holder
- Flexible and stable! Display your tablet PC to maximum effect.
- Equally suitable for the stage, home and studio
- For screens from 6 to 10.1" (width: 160-320 mm, height: 120-220 mm)
-The stand holder is an effective and secure attachment system for tablet PCs:
-
guaranteed by the integrated spanning tension spring and the side guard arm (3)
- A secure hold is provided by the integrated moss rubber protectors on the spanning
-
clamping jaws, vibration sound is eliminated and the tablet housing protected
- Connects to all microphone stands with a 3/8" internal thread
- Adjustment options to fulfil every requirement:
tablet size, tilt angle, direction, portrait/landscape format: all adjustable to suit the
-
user's requirements
Thank you for choosing this product. These instructions contain information about the installation
and use of the tablet PC holder. We suggest you keep the instructions in a safe place for later use.
SAFETY NOTES
- The stand must be sufficiently stable and have a 3/8" threaded bolt, e.g. K&M microphone stands
-
199, 200, 21020, 21090, 210/6, 210/8, 252, 259, 260, 260/1, 27105, etc.
- Screw the stand holder onto the stand: we recommend 3 turns
- Please place the tablet PC in the cradle carefully and check it sits securely
- Manoeuvre the stand holder with care; be certain the tablet is securely held before adjusting
-
(tilt, format and direction)
INSTALLATION (A-I)
A PREPARE THE STAND
A
(see Safety Notes above)
B LAY OUT THE COMPONENTS FOR 19742 IN ORDER
B
1 Tablet cradle
B
2 Swivel joint
B
3 Guard arm
C PRE-ADJUSTING THE TABLET CRADLE
C
4 Ensure that the "large latch" is disengaged -
C 4
look for the 3 mm gap (see Fig.)
C 4
Slide the "large latch" upwards, applying gentle
C 4
strength. There will be an audible click.
C
5 Slide out the upper section:
C 5
The distance between the sides should be
C 5
approx.10-15 mm less than the height or width
C 5
of the tablet PC.
C
6 Slide the "large latch" back down (there should
C 6
be an audible click)
D CONNECTING THE SWIVEL JOINT TO THE MICROPHONE STAND
D 1
7 First, turn the knurled disc on the screw mounting of the stand as
D 1 7
far as it will go
D 1
8 Swivel joint - also turn this on the screw mounting
D 1 8
– but not as far as it will go – we
D 1 8
gap of approx. 3 turns
D 1
9 Turn the knurled disc in the opposite direction until there
D 1 9
is no more free play between it and the swivel joint
D
10 Tighten the wing nut
E ATTACHING THE GUARD ARM
E
11 Place the guard arm in a suitable groove of the
E 11
swivel joint in such a way that the end sits closely
E 11
with the tablet (11a)
E
12 Important:
E 12
The tablet PC must be aligned centrally
E 12
(see points 26 and 27), if necessary, correct the
E 12
position of the guard arm.
recommend leaving a
Werbung
