Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Store dry!
Always drain the tank and please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.
WEEE Directive
When to be definitively put out of operation, take the unit(s) to a local recycling plant for a disposal
which is not harmful to the environment. Do not dispose of as municipal waste. Contact your retailer or
local authorities for more information.
STARTING OPERATION
Install the device on a plane surface.
Only install the machine on scratch resistant and water resistant surfaces.
The liquid tank of the device needs to be filled with bubble liquid before starting up operation and always
disconnected from the mains as fluid could be spilled.
If fluid should get into the interior of the device, disconnect from mains immediately and consult a technician.
Procedure and safety instructions for tank filling
Ensure your bubble machine is unplugged from the mains electrical supply before opening the
housing.
Remove the two safety screws on both sides of the device with the
required screwdriver. (see drawing, 1).
Once these are removed, the finger screws can be undone by hand
(see drawing, 2).
Once the screws are removed, the lid of the housing can be carefully
swung upwards, as shown above and the fluid tank can be removed
for refilling. Take care not to spill any of the bubble fluid inside the
unit.
The fluid tank is designed to fit only one way around. Make sure you
insert it correctly, as shown above, with the lower edge facing into the
machine.
Caution: It is essential to ensure that the housing remains open and
stable during filling and cannot open independently; you can hurt
yourself by sharp edges on the housing!
14/19
00094122.DOC, Version 1.1
Werbung
Inhaltsverzeichnis
