Warranty; Ec Declaration Of Conformity - Bresser Science TFM-201 Schnellstartanleitung

– Make sure the residual moisture is fully eliminated before use.
– Disconnect the device from the power supply by pulling the power plug when it is not used or in
case of longer interruption of operation and before starting any work on maintenance and cleaning.
– Only use a dry cloth to clean the exterior of the device. To avoid damaging the electronics, do not
use any cleaning fluid.
– Do not use organic solvents (e.g. alcohol, ether, acetone, xylol or other dilutions) to clean
lacquered parts or plastic parts!
– Disassemble optical elements (e.g. objective, eyepiece, etc) before cleaning.
– Blow away loose dust from the lens surfaces first.
– Use high quality lens cleaning towels or soft cloth and moisten it with a little bit of pure alcohol
(available in a drug store). Wipe the lens surface with it.
– Pull a dust protection cover* over the microscope and store it in a closed container at a dry and
mould-free place. Store the microscope and the accessories in the relevant containers when they
are not used for a longer time. It is recommended to store also objectives and eyepieces in closed
containers with desiccant.
(*depending on the model a dust protection cover and box can be part of the content)
NOTICE
Remember:
A well maintained microscope will keep its optical quality for years and thus maintain its value.
13 Disposal
Dispose of the packaging materials properly, according to their type, such as paper or card-
board. Contact your local waste-disposal service or environmental authority for information
on the proper disposal.

14 Warranty

The regular guarantee period is 2 years and begins on the day of purchase. To benefit from an exten-
ded voluntary guarantee period as stated on the gift box, registration on our website is required.
You can consult the full guarantee terms as well as information on extending the guarantee period and
details of our services at www.bresser.de/warranty_terms.

15 EC Declaration of Conformity

Bresser GmbH has issued a "Declaration of Conformity" in accordance with applicable
guidelines and corresponding standards.
QS_Science_TFM_Infinity_de_en_BRESSER_v1116
Imprint | 13
15 / 16