4
Chapter
Getting Started
The PRE16/26 Preamplifier can be switched on by pressing the power button on the front panel.
The blue ‹ ON › LED will light up if the device is powered-up.
On the front panel, every channel has a Clip LED indicator to control the input levels. Each input
channel also features 2 buttons and a series of green indication LED's to control the routing of the
input signal (Only PRE26). For the output section, every zone has its own 6 segment LED bar,
master volume control knob and 2 band control knobs to control the output signal.
The volume of the input signals can be controlled by turning the volume knobs of the input
signals on the front panel of the PRE16/26. The master volume knob and the 2 band tone control
knobs allow you to adjust the volume, bass and treble of the output signal. A VU-bar indicates the
signal level of the output signal.
12